Dunn-Rite Splash+Shoot DMB200 Istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Accessories Dunn-Rite Splash+Shoot DMB200. Dunn-Rite Splash+Shoot DMB200 3. Deck mounted

Stampa la pagina

All parts on Deck Mount WaterVolly and Deck Mount Splash+Shoot less one anchor

1. DeckVolly is warranted to the original owner for 1 year from date of purchase, with proof of purchase. This warranty

covers defects in materials and workmanship.

2. Parts returned under this warranty will be inspected. Damage which, in our judgement, occurred because of misuse,

negligence or accident is not covered by this warranty. This warranty is void if the product has been altered or tampered

with in any way.

3. Owner may send parts presumed defective directly to Dunn-Rite Products, freight prepaid. If Dunn-Rite agrees that

the products are defective and covered by this warranty, Dunn-Rite will repair or replace at its option, and return the

parts, with no charge for repairs.

In no event shall Dunn-Rite Products be liable for incidental

or consequential damages of any nature or kind, or for damages

to persons or property.

* If a part is missing or installation help is needed,

call our HELPLINE for a quick response.

800-798-9646

STEP 3

CUSTOMIZE NET LENGTH

Take unattached end of net to other stand and determine ideal length. Using scissors cut top vinyl

trim (C1) 1" past selected downward running rope (C2). BE CAREFUL when cutting to AVOID

CUTTING MAIN SUPPORT ROPE (C3). Then cut off unwanted netting just past knots (C4) but

LEAVE THICK BOTTOM CORD (C5) LONG ENOUGH to tie to bottom clamp on stand. Remove

the thin tension rope from grommet on end of net to use later. Pull unwanted piece of net off

top rope, cut top cord to desired length and tie to top clamp (C6). Move stand away from pool

till rope is taught. Take scissors and punch a ¼" horizontal slot between 2 stitch lines on vinyl trim.

Center between 2 outer downward net ropes (C7). Take the brass bolt and run it through a brass

washer, through slot in vinyl trim, through other brass washer and loosely tighten with the brass

nut (D1). Take the saved thin tension rope and wrap center around bolt (D2) between the vinyl

trim and washer, pull net tight and tie thin tension rope to clamp (D3). Tighten brass bolt (D1)

using two adjustable wrenches or pliers. Then tie bottom thick cord to bottom clamp (D4).

Make final tension adjustments and cut off any excess rope/cord at clamps. Then singe all

ends with a flame so they don't unravel.

BREAKDOWN

To remove post from anchor, loosen bolt in anchor and then tap bolt head down with wrench.

PART

Net Clamps...............................4

Hand Knobs..............................4

1"-Bolts.....................................4

Brass Bolt.................................1

COMBO HARDWARE PARTS LIST

with cap and one inflating needle.

VOLLEYBALL HARDWARE PARTS LIST

QUANTITY

PART

Brass Washers..........................2

Brass Nut..................................1

Post Cap....................................2

Net.............................................1

WARRANTY

2200 South J Street Elwood, IN 46036

Item No. DMV100

QUANTITY

PART

Ball with Inflating Needle...........1

Post with Finishing Ring............2

Anchors with caps......................2

Fax 7655527773

QUANTITY