AudioControl LCQ-1 Manuale di installazione rapida - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione rapida per Convertitore multimediale AudioControl LCQ-1. AudioControl LCQ-1 10. Six channel line output converter with multi-channel equalization and accubass

Stampa la pagina

More Highlights

Summable Outputs

The LCQ-1 has the capability to combine together multiple (2, 4, or 6)

input signals from the factory source unit into 2 channels. In some vehicles

there is an actively crossed over tweeter, midrange, and woofer all in the

front of the vehicle. The LCQ-1 lets you take all of those signals and sum

them together to get a high quality, full range, pre- amp signal. Simply move

the summing jumper located under cover and near knobs for the desired

channel into the "Sum" position. If the green LED for that channel is on, you

know it is being summed into the main output.

AutoMode Inputs

We have equipped your LCQ-1 with an AutoMode input that takes the

channel 2 (rear) input signal and automatically feeds it to the channel 3 out-

puts to drive a subwoofer amp and crossover. This means your LCQ-1 will

accept two input channels (say, Front and Rear) and give you three output

channels (Front, Rear, and Sub).

Optional Remote Level Control/EQ Switch

The ACR-2 is a multi-function remote that gives you control over the level

of the Channel 3/Subwoofer output so you can balance the bass level with

the rest of the system. An additional feature of the ACR-2 dash remote is that

it allows the equalization to be switched in and out of the audio circuit by

tapping the switch. You can hear the system before and after the EQ adjust-

ments.

ACR-2 Dash Control (Purchased Separately)

Placement And Mounting

The ACR-2 dash control may be mounted under the dash using its own

bracket or through a custom hole in the dash. It should be within reach of the

driver and in a spot where the LED is plainly visible.

Bracket Installation

The dash control mounts with two screws, which attach to the underside of

the dashboard. Slide under the dash and place the dash control in its mount-

ing position, mark the two mounting holes, drill pilot holes, and secure with

two screws.

Custom Installation

For that custom, ﬁnished look, the dash control can be

ﬂush mounted directly on the dash-board (or any-

where else). Referencing the ﬁgure above,

disassemble the dash control from the

mounting bracket. Start by pushing the

LED from its holder followed by

removing the circuit board and

rotary control from the bracket.

Drill a 9/32 hole in the dash-

board for the control along with

a 1/8 hole for the lock tab and

a 13/64 hole for the LED holder.

Reassemble the dash control components on the dashboard.

Dash Control Assembly

page 5