Audiodesksysteme Gläss Vinyl Cleaner PRO Manuale di istruzioni per l'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Pulitore a ultrasuoni per gioielli Audiodesksysteme Gläss Vinyl Cleaner PRO. Audiodesksysteme Gläss Vinyl Cleaner PRO 13.
Anche per Audiodesksysteme Gläss Vinyl Cleaner PRO: Manuale di istruzioni per l'uso (14 pagine)

Audiodesksysteme Gläss Vinyl Cleaner PRO Manuale di istruzioni per l'uso
5. Maintenance/ replacement parts
5.1 Changing the cleaning barrels
The 4 microfibre cleaning barrels (7) are highly stabile, but as best practice should be exchanged
after approximately 500 cleaning operations.
In this case pull the cleaning barrels straight up and off one at the time. The new barrel is placed on
the axle from above and firmly pushed down. The „key hole" on the barrel must line up with the
actuating pin glides into the hole on the barrel and then press the barrel down as far as it will go.
Picture 5:
Fixing and/or removal of the cleaning barrels
5.2 Cleaning of the moisture filter
The cleaning fluid is constantly filtered when the apparatus is in use. The filter
should occasionally be checked, rinsed or replaced depending on the degree of
soiling.
In this case remove acrylic filter cover and the sponge-like filter below it. Soak the
filter several times with distilled water and squeeze the fluid out.
Then replace the filter from above pushing it all the way to the bottom of the filter chamber.
(NOTE: Should the filter not be pushed down fully water may leak from the apparatus during operation!)
Afterwards place the acrylic filter cover.
Picture 7:
Fixing and/ or removal of the filter
Picture 6:
View of the actuating pins for the cleaning barrels
Accessories
Picture 10:
Filter
Cleaning concentrate
Microfibre cleaning barrels (set of 4)
Fan Filters (set of 2)
Page 4
White wipers (set of 2)
Drive rings (set of 2)