AudioEngine W3 Manuale di configurazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di configurazione per Adattatore AudioEngine W3. AudioEngine W3 4. Premium wireless audio adapter
Anche per AudioEngine W3: Manuale di configurazione (1 pagine)

How to Pair
Multiple W3 Receivers may be paired with one Sender,
allowing the Sender to simultaneously broadcast audio
to all Receivers, with no degradation of the audio signal.
Pairing a Sender and Receiver:
1) Press and hold the pair button on the W3 Sender for about
5
seconds until the status indicator blinks rapidly.
W3 Sender and Receiver sets packaged together are
already paired, so if you're only using one setthey
2)
Now go to the Receiver, then press and release the pair
button on the W3 Receiver.
will remember each other and no further configuration
is needed.
3)
Both Sender and Receiver status indicators will turn solid,
indicating they are paired.
The following procedure explains how to add additional
W3 Receivers to a Sender or to pair a Receiver to another
Sender.
4)
Repeat these steps to pair with additional Receivers.
Once a Sender and Receiver are paired, they will remember
each other.
Troubleshooting
Here are a few tips to try if your W3 is not performing as it should.
Sender and/or Receiver status
indicators are not lit:
Sender and Receiver status
indicators are both blinking:
Sender and Receiver status
indicators are both solidly lit,
but no audio:
Support
• Check that the Sender and Receiver are connected to power (from a USB port and/
or power adapter).
• If using a computer, verify that the Sender (and not the Receiver) is connected to
the computer's USB port.
• Repeat the Sender/Receiver pairing process (see''Howto Pair'' above).
• Check that the Sender is connected to the desired audio source and the Receiver's
output is connected to the correct audio input.
• Check that all cables are properly connected. Unplug and reconnect each to verify.
• Check that your desired audio output source (into the Sender) is present.
• Check that the Receiver's output is connected to the device which is powered on
and working.
• If connected to a computer, verify that USB Audio Device "Audioengine W3" is
selected in your system (see "Configurations" #1 ).
• If connected to a computer and using iTunes, verify that "Computer" is selected in
the lower right corner of iTunes.
• If using a computer, check that the Sender (not the Receiver) is connected to
the computer's USB port.
If you have any questions or feel you may need service, contact us via email: [email protected]
or call toll-free in the United States: {877) 853-4447
Technical Specifications
Item
Condition Specification
Item
Output level
mV
680
Signal- Noise Ratio
Frequency Response 100 Hz
dB
o
~----+--------+--------~
(l
kHz=OdB)
10kHz
dB
0
THO
%
0.1
Effective Distance (typical)