Audiofrog A600.1D Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Amplificatore Audiofrog A600.1D. Audiofrog A600.1D 8. 4/1-channel high fidelity class-d amplifier

Connections: A150.4D

GND

+12V

GND: Connect to the metal part of the ve-

hicle's body. Scrape away paint to ensure

a low resistance connection. Do not tin the

wire with solder.

+12V: Connect to the + terminal of the

vehicle's battery. You MUST install a fuse

holder with a 60A fuse within 18" (45cm) of

the battery's terminal to protect the power

wire and the car in case of a short circuit.

Do not tin the wire with solder.

REM

REM: Connect to the remote turn on circuit

of the head unit or the vehicle's accessory

circuit. Alternately, use the offset or signal

sensing feature of the amplifier. Signal

sensing works with the low and high level

inputs. Do not tin the wire with solder.

HIGH LEVEL INPUT: These can be connect-

ed to the outputs of the head unit or the

factory installed amplifier intended to drive

speakers directly. Be sure to observe prop-

er polarity. DO NOT EXCEED 30Vp.

LOW LEVEL INPUT: Connect these to the

RCA type outputs of an aftermarket head

unit or preamp adapter or the low level

output of a factory installed head unit.

OUTPUT: Connect to speakers with an

impedance of at least 2Ω. To bridge the

amplifier channels, connect one speaker

to 1+ and 2- and connect the other speak-

er to 3+ and 4-. The minimum speaker

impedance in bridge mode is 4Ω. Do not

tin the wire with solder.