Conquip Drag Box Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Attrezzature per l'edilizia Conquip Drag Box. Conquip Drag Box 10.

Original Working Instructions

Usage Instructions

Assembly Instructions

1. Using certified lifting slings connected to the four handling points place a

base side panel with the flat face down.

2. Place struts of equal lengths into all connection points protruding from the

panel and secure them using the pin and R-clip supplied. (Fig 1.1)

3. Connect the sling to the four handling points of the opposite base side panel

(flat face up) and lift into position above the struts.

4. Secure the struts to the panel with the remaining four pins and R-clips.

(Fig 1.2)

5. Disconnect the lifting sling and connect to two of the lifting points on the top

assembly. Lift to rotate into its working position. (Fig 1.3)

Fig 1.1

Fig 1.3

User Guide - Drag Box

Fig 1.2

Original Working Instructions

Usage Instructions

Connecting Extensions Boxes

1. The base box and extension box are connected by inserting a pin through a

plate on the base panel and slot in the extension panel.

2. There are 2 plates welded to the top of every base panel that protrudes from

the top. There are 4 connecting points per box.

3. The plate hole aligns with a slot in the bottom of the extension panel. Once

aligned, insert the 45mm pin from the inside of the drag box so the pin hides

within the depth of the box.

4. Secure each pin in position with an R clip.