Daniela DAN6UC Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Cappa di ventilazione Daniela DAN6UC. Daniela DAN6UC 17. 60cm concealed rangehood

INSTALLATION OF ELECTRICAL

Electrical wiring must be done by a qualified person(s) in accordance with all applicable codes

and standards. This range hood must be properly grounded. Turn off electrical power at service

entrance before wiring. If the supply cord is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualified persons in order to avoid a hazard. Do not use the plug and

an extension cord other than the ones initially supplied with the hood.

INSTALLATION OF THE HOOD

NOTE: On stainless steel hoods, carefully remove the plastic protective film from all exterior

surfaces of the hood and chimney prior to final installation.

NOTE: At least two people will be required to mount the hood.

Before beginning installation, and to better handle the hood, we advise removing the face plate.

Attach the air outlet adapter over the hood. Tighten it with 4 screws.

The range hood is designed to operate with 150mm exhaust Ducting.

FIXING UNIT IN CABINETRY

Before fixing the hood to the unit, drill a hole of 165mm diameter for 150mm,

135mm or 120mm exhaust ducting in the wall unit.

Check the position of the power outlet and consider where the power cable will run, since a

hole might have to be made in the wall unit to accommodate it.

On the other side of the hood there are 2 spring steel fittings to assist the installation.

Adjust the height of the spring steel to match the thickness of the mounting panel.

The hood can be slid into the opening and these springs will take some of the weight

while the mounting screws are fitted.

Lift the range hood and fit through the opening of the cabinet. Secure the unit by using

4 long mounting screws (ST5*45) =. Two into each side.

Refit the filter and close the panel.

Make the electrical connection.

NOTE

•

Exhaust air must not be discharged into a flue which is used for exhausting fumes from

appliance burning gas or other fuels.

•

If the instructions for installation for the gas hob specify a greater distance that 750mm,

this has to be taken into account.

•

The regulations concerning the discharge of exhaust air have to be followed.

•

Check with the local authority for building codes for exhaust ducting requirements.

PA G E 8

02 9604 1226

danielaappliances.com.au