Belcat UK-300T Manuale d'uso - Pagina 2
Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Belcat UK-300T. Belcat UK-300T 3. 2band eq with chromatic led tuner
Stampa la pagina
INSTALLATION MANUAL
1. Contents
2. Output Jack
1. Preamp
2. Tool
1. Electric Drill
2. Drill Bit
(2.3mm or 3mm and 12mm )
3. Phillips Screwdriver
3. Insert EQ and battery box into hole of guitar.
4. Fasten screws properly.
6.Installing the pick-up
Pick-up
wire
3. Pick-Up
4. Clip
5. Screw
4. Router and Grinder
(cutting-edge 3mm)
5. Round File
6. Masking Tape
5. Put plugs
into jacks.
1. Cut out the hole with template
Cutting
Masking
Template
T
ape
Preamp
2.Drilling hole for pick-up
7. Fix wire with clip
.
Clip
EQ
Pick-up
Wire
Solution
1) When there is no sound or sound is stopped,
- Check guitar cable, amp or Mixer
- Check if there is batter or not. When it happens noise or distortion,
please exchange battery.
- Check if the pickup and battery connector is connected correctly
or not.
- Check if out put jack is connected correctly.
2) When there is hum-noise,
- Check the pickup is connected well or not.
- Check if the connectors are connected to correct position well
or not.
3) Some causes of the balance problem
- When the bottom of saddle or the groove of saddle is not flat.
- When saddle is installed to the groove of saddle loosly.
- When the connection is not good between the bottom of saddle
and the groove of saddle.
- When Saddle is very short
- When there is grounds on the groove of saddle.
- When Saddle is declined toward front or back.
- When the top of guitar is bended.
- When the pickup is installed to only a part of the groove of saddle.
(back page)
Masking
T
ape
12mm
Out put Jack
Out put jack
Cable
Out put
Jack