Audionet AMP 1 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Audionet AMP 1. Audionet AMP 1 8.

Switching on

Switching off

Note

Protection circuit

Operating the system

Before switching on your AMP I please ensure that all cable connections

are in best condition and the connected preamplifier is already switched

on.

To switch the AMP I on, please press the „power" button on the front

panel. Because of absence of any relay in the signal path, switching on

may cause a soft „plop".

To switch the AMP I off, please press again the „power" button on the

front panel. The amplifier now still works for about 8 seconds, until the

power capacitors are discharged. Now the music stops.

To enable „remote controlling" by Audionet-link, after switching off the

AMP I is always in stand-by state with low power consumption. Only in

case of longer absence the AMP I should be disconnected from the power

supply (mains unplugged).

Your AMP I has a powerful protection circuit to prevent damage of the

amplifier itself or the loudspeakers connected. In case of trouble the

AMP I is switched to stand-by state. The problem source is indicated by a

flash code of the LED next to the „power" button:

short short short:

short short long:

short long short:

short long long:

long short short:

long short long:

long long short:

long long long:

overload / short-circuit

overheat

high frequency oscillation

direct current (DC)

left channel

right channel

left channel

right channel

left channel

right channel

left channel

right channel