audiophony Ti154 Manuale d'uso - Pagina 6
Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore audiophony Ti154. audiophony Ti154 12. 4-channel 4x150w amplifier at 4 ohms
Stampa la paginaEnglish
Rear panel
1
BALANCED
INPUT
BRIDGE
PARALLEL
CH 4
CH 3
STEREO
2
[1] - "Combo" input connector
Allows you to receive line-level signals. This socket
is able to receive both symmetrical and asymmetrical
signals. However, we recommend to always use
symmetrical signals as they get you rid of parasitic noises
caused by low quality cables. Connect here your male
XLR plug or Jack 6.35 TRS plug. Polarities are spread as
follows:
- Pin 2 = Signal +
- Pin 3 = Signal -
- Pin 1 = Ground
[2] - Parallel / Stereo / Bridge Selector
Allows you to select the current amplifier mode:
- Stereo : Standard mode, each channel amplifies its
own signal. (Minimum impedance of 4 ).
- Parallel : Inputs 1 and 3 signals are identically amplified
by all four channels. (Minimum impedance of 4 ).
- Bridge : Both amplification channels are added up to
amplify Inputs 1 and 3 signals. (Minimum impedance of
8 ).
Page 6
BALANCED
INPUT
CH 3
BRIDGE
BRIDGE
PARALLEL
CH 2
CH 1
CH 4
STEREO
Ti154 - 4-channel 4X150W amplifier at 4 Ohms
OUTPUT
4
3
CH
CONNECT 2
3
4
[4] - Speakon® outputs
Allow you to connect your speakers via cable equipped with
Speakon® connectors.
Each Speakon
®
output matches to 2 channels.
CONNECT 1 matches channels 1 and 2.
Speakon
®
Pins 1 and 2 of CONNECT 1 match channel 1
while pins 3 and 4 match channel 2.
CONNECT 2 matches channels 3 and 4.
®
Speakon
Pins 1 and 2 of CONNECT 1 match channel 1
while pins 3 and 4 match channel 2.
Please refer to next chapter for more information about
connections.
[5] - Outputs via Pomona terminal
Allow you to connect your speakers via Pomona connectors
or directly connect stripped cables. Use the white terminals
to connect your speakers in Bridge mode. Caution:
dangerous output voltage.
[6] - Power input socket
Connect here the supplied power cord.
2
1
CH 1
BRIDGE
CH 2
CONNECT 1
5