audiophony Ti500 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore audiophony Ti500. audiophony Ti500 12. Ti series professional stereo amplifiers

Stampa la pagina

Ti SERIES - Professional stereo amplifiers

4 - Description

4.1 - Front panel

[1] - Mounting brackets

Allow you to install your amplifier within 19" (482mm)

racks.

[2] - Power button

[3] - Indicator LEDs

Signal LED:

This green and yellow LED lights up when a signal

is detected via one of the input.

Clip LED:

Lights up when the clip threshold has been

reached to indicate the input is saturated and its

output signal might be distorted.

Adjust the level output of your source in order to

correct this and prevent damages to your speaker

and amplifier. The sound quality will drastically

improve as well.

Note: Ti amplifiers feature two identical

channels (1 and 2), the description below

refers to a single channel for legibility

concerns.

Protect LED:

Lights up to indicate the channel is in protection

mode, the output will then be "cut" by an internal

relay.

Usually the Protect mode is activated when the

channel is overheating or serious problems occur

in order to protect speaker(s) connected to this

channel.

This LED briefly lights up upon activation of your

amplifier in order to avoid sending voltage peaks

to your speakers during the initialisation of your

amplifier.

[4] - Input attenuator

Each channel features its own input attenuator

allowing you to limit the incoming signal level.

This attenuator has 21 different levels. When on

the left, the signal is attenuated by 80 dB, when

on the right the signal is not attenuated and the

amplifier operates at full power. In mono bridged

mode, attenuator 1 affects both channels.

In Parallel mode, each attenuators only affects its

own channel.

ENGLISH

Page 5