audiophony CR25A-COMBO F8 Manuale d'uso - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso per Sistema di altoparlanti audiophony CR25A-COMBO F8. audiophony CR25A-COMBO F8 15. Bluetooth sound system with usb/sd player & 2 handheld mic
Anche per audiophony CR25A-COMBO F8: Manuale d'uso (15 pagine)

Stampa la pagina
audiophony CR25A-COMBO F8 Manuale d'uso
English

4 -Description of the modules

4 - 1 : UHF receiving module
5
6
RF
AF
DOWN
UP
MUTE LEVEL
4
3
2
7
4 - 2 : USB/SD/Bluetooth
2
1
1
st
Bluetooth
®
pairing:
Switch to Bluetooth
mode. The display will indicate «BT NOT LINK», then «connecting...» for a few seconds.
®
Turn your Bluetooth
source ON and scan for devices.
®
Select «Bluetooth» in the list, and accept the pairing.
The CR12A-COMBO display should indicate the name of the connected device.
20
120W B
CR120A-COMBO -
A1 - Volume control fader for the HF module. From OFF to full power
8
9
(clockwise).
A2 - Squelch control fader: allows you to configure the threshold in
case of HF signal interruption. The factory settings do not require
any modification.
A3&4 - Canal selection: allow you to browse through the 16
available frequencies.
IR
A5 - Frequency display.
8
A6 - Radio Frequency indicator: this indicator is lit in red when the
emitting mic is ON.
12
4
A7 - Audio Frequency indicator: this indicator is lit in green when a
OFF
15
signal is being received.
POWER-VOL
A8 - ASC (Auto Synchro Connection) button: allows you to
synchronise a channel between the transmitter and receiver. Select
1
a channel (from 1 - 16), press the ASC button and put the IR (#6)
diode of your mic in front of the IR (#9) diode of your receiver.
A9 - IR diode. Allows you to synchronise your mic with the receiver.
module
®
3
6
®
LUETOOH
SOUND SYSTEM WITH
4
5
USB
2
PLAYER AND
UHF HANDHELD MIC
B1 - Channel 1 input selector. Allows
you to decide if the player or the Aux
input will be active on channel 1 of the
mixer.
B2 - SD card slot.
B3 - Reader display.
B4 - IR diode to receive the remote
control commands.
B5 - USB mass storage socket for
USB key.
B6 - Command panel of the reader:
MODE:
Allows you to switch from USB/SD to
the Bluetooth
receiver: the display
®
will indicate «BT NOT LINK», and
«connecting» for a few seconds when
you switch to Bluetooth
®
MODE.