DanPure LUXE 75 Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Distributore d'acqua DanPure LUXE 75. DanPure LUXE 75 8.

Stampa la pagina

To Dear Customers

Congratulations for choosing our RO water dispenser system

puts end to bottled water deliveries by filtering your customer's own water

supply of contaminants and bacteria

supply of crystal clear, filtered water.

Note

The unit is not intended for use with water that is microbiologically

unsafe or of unknown quality without adequate disinfection either before

or after the system.

Note

Check with your public works department for applicable local

plumbing and sanitation codes

standards used in this manual. To ensure proper and efficient operation of

the unit to your full

satisfaction,

manual.

Caution

1.This appliance is not intended for use by persons (including children) with

reduced

physical,

sensory or mental

knowledge,

unless

they have been

concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the

appliance.

2.If the supply cord is

damaged,

service agent or a similarly qualified person in order to avoid a hazard.

3.The new hose-sets supplied with the appliance are to be used and that old

hose-sets should not be reused.

4.Do not store explosive substances such as aerosol cans with a flammable

propellant in this appliance.

5.To avoid a hazard due to instability of the appliance, it must be fixed in

accordance with the instructions.

6.This appliance is intended to be used in household only

How to install the unit

Step1. Remove the screws located on the left and right-hand corner at the

bottom of the back board

Step2. Use the removed screws to fix the L-shape fixer on the left and right-hand

corner at the bottom of the back board at a suitable

Note

the end with a slot should be fixed to the back board

Step3. Drill two holes suit to the dimension of expansible tube (about φ 7 mm in

diameter) in the proper floor and insert the expansible tubes into the two holes

Make sure it is inserted in place and firmly .The distance between the two holes

should be as following: 275 mm

Note: the centre line of the two holes should be at least 275 mm from the floor.

Step4

Lift up the unit and make the hole of the L-shape fixer aim at the hole

located on the floor, and then let down the unit. Use two screws provided to fix

the L-shape fixer on the floor

resulting in a virtually endless

Follow local codes if they differ from the

carefully follow the instructions in this

capabilities,

or lack of experience and

given supervision

it must be replaced by the manufacturer

height.

This model

or instruction

its