CASO DESIGN 11862 Manuale operativo originale - Pagina 12

Sfoglia online o scarica il pdf Manuale operativo originale per Distributore d'acqua CASO DESIGN 11862. CASO DESIGN 11862 16. Instant boiling water dispenser

Stampa la pagina

5.1 Before initial use

1. Place the device in a safe location and plug it in.

2. Please do not use the filter at this moment yet.

3. Fill the water tank with approximately 4 cups of water.

4. Remove the drip tray.

5. Place a large bowl in front of the device so that it collects the water that runs out of the

spout.

6. Start the device with maximum temperature setting.

7. Switch the device off, when the lamp lights in red.

8. Remove the plug from the wall outlet and let the device cool down.

9. Refill the water tank again with fresh water. The device is now ready to use.

Filter

Warning

► The filter is only intended to filter tap water. Do not use water of unknown quality or that

has been microbiologically impaired.

1. Remove the filter from all packaging. There may be a small residue of black carbon

particles in the bag or adhering to the cartridge body. This is normal. These particles are

harmless and will be washed off during the preparation process.

2. Soak the filter upright in water for 10 min.

3. Rinse the filter under running water for 10 sec.

4. The filter is now ready for use.

Please note

► The lifetime of the filter lasts about 4-6 weeks of normal use (filtering of approximately 650

cups of water in total).

► Store the replacement filter cartridges in a cool location, out of direct sunlight and away

from heat sources.

5.2 Use

1. Fill in water

1. Open the lid, fill the water tank with the desired amount of water.

2. Therefore you can also remove the water tank.

3. Close the lid.

Please note

► The water level must be less than the Max level and be at least at Min level.