Addonics Technologies RT5835HMEU Hardware

Sfoglia online o scarica il pdf Hardware per Immagazzinamento Addonics Technologies RT5835HMEU. Addonics Technologies RT5835HMEU 2.

Stampa la pagina

Installing drive into the RAID Tower V

Step 1

Use a Philips screwdriver to secure the 3.5"

SATA hard drive to the drive tray

Step 2

Slide the tray into the Disk Array drive bay.

Note: It is recommended to fill up the RAID

Tower V with SATA drives from right to left

and top to bottom. This is to help in identifying

which drives connect to which ports for easier

troubleshooting.

II.

Connecting the power cable and RAID Tower V to the

computer

Connect the power cord provided from the wall outlet to the back of

the RAID Tower.

Make sure the power is off (power LED light should be off).

Connect either the provided USB or eSATA cable from the back of

the RAID Tower to the computer. We recommend connecting the

eSATA port for best performance if this port is available on your

computer.

Photo identifying SATA port s on HPM

SATA

Port 3

SATA

Port 1

SATA

Port 2

Port 4

III.

Power on/off control

Turn on the power to the RAID Tower Mini by pressing the power

button on the front. The power LED light should lit indicating the power

is on.

ADDONICS TECHNOLOGIES

LED pins

Pin 1

Power LED

Power Switch

HPM 1 (Top disk array)

(LED 1) HPM Health

(LED 2) eSATA Status

(LED 3) USB Status

HPM 2 (Bottom disk array)

(LED 1) HPM Health

(LED 2) eSATA Status

(LED 3) USB Status

Model: RT5835HMEU

IV. Setting RAID on the HPM

Attach the SATA hard drives (up to 4) to the SATA ports on the

Hardware Port Multiplier (HPM) using SATA cables. It is

recommended to connect drives to the SATA ports 1 to 4

successively.

Set the Rotary switch to the RAID mode required.

Push the RAID setting button with a ballpoint pen tip while the HPM

is turned off.

Use a ballpoint pen

tip to press the

RAID Setting Button

While holding the RAID setting button, turn on the HPM and SATA

hard drives and continue to hold button for at least 5 seconds.

Note:

The onboard LED's for the eSATA and USB will start blinking

while holding down the raid setting button. Once the raid

setting button is released, the PM Health LED will blink 4-6

times.

If the PM Health LED stops blinking, the raid set is set

correctly. If the PM Health LED lights up as solid green, it is a

bad setup. You need to repeat setting up the raid again.

Set B

(4-drive HPM)

Set A (4-drive HPM)

Set B (4-drive HPM)

RAID

setting

button

RAID config

rotary switch

eSATA port

Power Switch

Power Connector

Set A (4-drive HPM)

USB port