Beldray BEL0747 Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Ferro Beldray BEL0747. Beldray BEL0747 16. Two in one cordless iron

STEP 6: Set the temperature control dial to the highest heat setting and allow the iron to

heat up until the temperature indicator light switches off.

STEP 7: Switch off and unplug the iron from the mains power supply.

STEP 8: Remove the iron from the iron stand and carefully hold it over a sink, making

sure that the power supply cord and plug are kept away from the ceramic soleplate.

STEP 9: Press and hold the self-clean button. Hot water and steam will expel from the

steam holes along with any impurities.

STEP 10: After approx. 1 minute or when the water tank is completely empty, release

the self-clean button.

STEP 11: Place the iron onto the iron stand and allow to cool thoroughly.

STEP 12: When the iron has sufficiently cooled, wipe it with a soft, damp cloth.

STEP 13: Plug in and switch on the iron at the mains power supply.

STEP 14: Set the temperature control dial to the highest heat setting.

STEP 15: Once the temperature indicator light has switched off, use the iron on an old

piece of fabric to remove any excess water and impurity build-up from in the steam holes.

Note: Water may be ejected from the steam holes whilst the

iron is heating up.

For best results, carry out the self-clean process immediately

after unplugging the iron from the mains power supply.

Caution: Never press the self-clean button when using the iron;

only press it when the iron is switched off and unplugged from

the mains power supply and is safely held over a sink.

Hints and Tips

Always start ironing on a low heat setting and work up to a higher one, if necessary; it

takes less time for the iron to heat up than it does to cool down.

The temperature of the iron is the hottest when it has initially heated up and will

therefore need time to stabilise. Once the iron has heated up, allow the temperature

indicator light to cycle off and on again before using the iron.

Storage

Check that the iron is cool and dry and that the water tank is empty before storing in a

cool, dry place.

Wrap the cord loosely around the iron; never wrap it tightly as this could cause damage.

Troubleshooting

Warning: To reduce the risk of fire, electric shock or injury,

switch off and unplug the iron from the mains power supply

before troubleshooting.