Dantherm CDF 50 Manuale

Sfoglia online o scarica il pdf Manuale per Deumidificatore Dantherm CDF 50. Dantherm CDF 50 6. Replacing rh/t sensor
Anche per Dantherm CDF 50: Installazione rapida (12 pagine), Istruzioni per il kit di assistenza (12 pagine)

Stampa la pagina

Replacing RH/T sensor (en)

Applies for the following products with serial no. lower than:

•

CDP/CDF 40: 1809131526904

•

CDP/CDF 50: 1809241528179

•

CDP/CDF 70: 1810031531072

Remove the front of the unit.

Remove the PPI filter and replace with new as

per partslist.

The new PPI filter must be right up against both

ends of the cabinet.

Make sure that the hole is furthest away from the

front as shown.

Note: For CDP/CDF 40 and 50 the filters

must be cut according to this illustra-

tion.

Release humidity sensor from drip tray

and retract it back in to the compressor

compartment.

In the compressor compartment pull the sensor

through the rear hole in the bottom plate.

Find the compressor compartment cover with

the pre-mounted bracket for the humidity

sensor.

Dismount the old cover.

Mount the new cover and move the sensor to

the front.

200mm

130mm

0mm

1237mm

Note: The bracket is

mounted off center

to fit the hole in the

PPI filter

1447mm