Belfort 134 04 11 Manuale tecnico - Pagina 5

Sfoglia online o scarica il pdf Manuale tecnico per Stufa a legna Belfort 134 04 11. Belfort 134 04 11 16. Belfort 4,5 kw wood or coal stove

"BELFORT" - ref. 134 04 11

2.4. Assembly of flue spigot and blanking

plates

The stove is supplied with a connection flue spigot with

an inner diameter of 125 mm or an outer diameter of

139 mm.

2.4.1. Smoke exit on the top

Figure 4

Remove the internal baffle ( # 17, page 13).

Fit the sealing rope in the groove and attach the flue

spigot (# 26, page 13) using the three bolts and

washers supplied.

Check that the two blanking plates are fixed to the

back wall (# 25 & 35, page 13)

Replace the internal baffle.

2.4.2. Smoke exit at rear

Figure 5

Remove the internal baffle (# 17, page 13) and the rear

heat shield (# 16, page 13).

Fix the sealing rope in the groove on the rear and fit

the flue spigot, ensuring there is a good seal.

Fix the sealing rope in the groove on the top and fit the

two blanking plates, ensuring there is a good seal.

Replace the internal baffle.

Remove the cut-out in the rear heat shield and re-fit.

2.5. Chimney connector

The appliance must be installed as close as possible

to the chimney.

The connector pipe must be approved for installation

with combustion products (either 24 ga. Black painted

or blued steel or 316 grade 20 ga. Stainless steel or 1

mm vitreous enamelled steel).

Pipe diameter must not be less than the appliance

spigot diameter. If there is no other solution, the

reduction can not be more than one diameter lower

than the flue spigot and be situated as distant as

possible from the flue connection of the appliance.

Technical manual "1174"

Figure 5 - Smoke exit at rear

Installation instructions

Figure 3 - Removing the flue baffle

Figure 4 - Smoke exit on the top