Constellation audio Inspiration PREAMP 1.0 Manuale d'uso - Pagina 7

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Constellation audio Inspiration PREAMP 1.0. Constellation audio Inspiration PREAMP 1.0 16.
Anche per Constellation audio Inspiration PREAMP 1.0: Manuale d'uso (16 pagine)

Stampa la pagina

When XLR connections are used to connect the PREAMP 1.0 with the Inspiration MONO 1.0, STEREO 1.0,

Centaur or Hercules amplifiers, the Constellation Link is created—an audio interface that is, in essence,

perfectly balanced. The positive- and negative-going halves of the signal will exhibit near-zero

difference except for their polarity.

4. RCA outputs

RCA unbalanced outputs are supplied for amps and recording devices not equipped with XLR inputs.

The signal at these outputs is the same—it does not matter if you use output 1 or output 2.

From left to right, looking at the back of the PREAMP 1.0, the outputs are: 1

, 2

——2

, 1

right

left

When connecting to an amplifier, be sure to match the output to the correct channel on your amp. As

you are looking at the back of the PREAMP 1.0, the outputs on the left side are for the right channel,

the outputs on the right are for the left channel. To remove an RCA plug, grasp it by the connector

body and pull the plug out.

Other connections on the PREAMP 1.0

5. USB / control

This USB jack on the back panel is used to

interface the PREAMP 1.0 with third-party control

systems such as those from AMX, Crestron and

Control4, and also to update the PREAMP 1.0's

firmware. For more information, contact your

dealer.

6. Trigger

This 3.5mm input jack on the back panel allows the PREAMP 1.0 to turn a connected device (such as a

Constellation Audio amplifier) on and off automatically. When the PREAMP 1.0 is powered up or in

Standby mode, this jack emits a 12-volt DC signal. When the PREAMP 1.0 is powered off entirely (by

holding the front panel power button down for 5 seconds), the jack emits no signal. This jack will work

with any device that can accept a standard 12-volt trigger signal.