CONTACLIP TTPCard Manuale d'uso - Pagina 9
Sfoglia online o scarica il pdf Manuale d'uso per Stampante CONTACLIP TTPCard. CONTACLIP TTPCard 11. Thermal transfer printer
Stampa la pagina
•
Remove the current printing template.
•
Attach a new cleaning pad to the cleaning template and spray cleaning fluid across its full
width. Correctly locate the template on the carriage.
•
Press the green button to start the cleaning cycle.
•
At the completion of the cleaning cycle the carriage will stay open and the TTPCard in
'Cleaning mode' should it be necessary to repeat the cleaning cycle.
•
To exit from 'Cleaning mode', switch the TTPCard OFF, then ON again after a few seconds.
Remove the cleaning template, detach and discard the used cleaning pad then store the
components of the cleaning kit in their original packaging in a dust free, dry environment.
Do not re-use cleaning pads, sets of 5 spare pads are available, order part code 28044.0.
WARNING: Use only genuine CONTA-CLIP cleaning materials and methods with the TTPCard. The
use of any other materials or methods may cause irrevocable damage to the print head and/or void
any remaining warranty.
5.2
Routine cleaning
Keep internal and particularly moving parts free from dust by wiping with a soft cloth. To remove stains
or residue from external metal and plastic parts, use a soft cloth just dampened with a neutral
detergent. Remove grease, print and adhesive residue from templates with alcohol cleaner
and a clean, soft cloth.
Do not allow fluids to come into contact with electrical parts or the ribbon or to remain on
moving parts. Wipe up all spills.
As much as possible, avoid the ingress of environmental contamination, eg dust, into the TTPCard. Fit
the protective cover when not in use.
5.3
Replace fuses
The TTPCard electrical circuits are protected against overcurrent by two 2A phase and neutral fuses in
compartment (10) located at the back of the TTPCard. Replacement fuses must have exactly the
same characteristics as the ones replaced. Disconnect the TTPCard from the mains supply before
opening fuse compartment (10). Ensure fuses and compartment are correctly relocated before
reconnecting the mains supply.
6.0
Warranty
The TTPCard is guaranteed for one year against inherent faults and defects. The print head is classed
as a consumable and not covered by the guarantee. The guarantee is void if parts used are not
CONTA-CLIP original ones.
7.0
Troubleshooting
The TTPCard is equipped with self-diagnostics which notify the user in the event of certain 'fault'
situations by means of a combination of flashing LEDs and an audible alarm.
Alarm indications:
GREEN LED (1): remains lit when the TTPCard is ON and ready for use.
This LED blinks when the print head malfunctions or is disconnected or damaged.
YELLOW LED (2): blinks during the print cycle process with the relative movement of the
carriage.
ORANGE LED (3): mainly signals TTPCard errors or failures, the nature of which are
identified by the number of LED blinks and audible beeps, as follows:
9