Contacta HLD7 Manuale d'uso - Pagina 11
Sfoglia online o scarica il pdf Manuale d'uso per Apparecchi acustici Contacta HLD7. Contacta HLD7 20. Hearing loop driver
Anche per Contacta HLD7: Manuale d'uso (16 pagine)
Secondary Driver Setup*
MIC
MIC
CLIP
CLIP
ACTIVE
ACTIVE
PHTM
PHTM
1. Confirm that the driver has been set to the SECONDARY mode
(see page 12). In this mode the driver follows the signal sent from the
primary or perimeter loop driver.
2. Connect an RJ45 cable between the expansion jack of the primary/
perimeter driver and the expansion jack on the secondary driver.
Note: if connected to a primary driver the driver outputs are 90
degrees out of phase (for a phased array).
3. Nothing should be connected to the LINE or MIC input jacks on the
back of the secondary driver, and the input controls are not used on
the secondary driver apart from the drive level.
4. To enter the "Adjustment Mode" push the DRIVE ( + and - ) buttons
simultaneously until the status light begins to flash on and off.
5. If setting up a phased array bring the current level up until the
DRIVE output lights from primary and secondary driver match, after
releasing the controls. Note: there are 8 button pushes between each
output light. In the phased array you want the same signal level in the
centre of the secondary loop as you have in the primary.
Assumes unit is properly connected and loop has continuity.
*
contacta HLD7
contacta HLD7
LINE
LINE
CLIP
CLIP
PERIMETER
PERIMETER
ACTIVE
ACTIVE
PRIMARY
PRIMARY
LOW SIG
-20DB
SECONDARY
SECONDARY
To adjust drive when you have selected your mode press
DRIVE + and - together. The status LED will flash.
•
Press DRIVE + to increase level.
•
Press DRIVE - to reduce level.
Press DRIVE + and - together when adjustment complete.
1 2 3 4 5 6
1 2 3 4 5 6
-
-
-
-
DRIVE
DRIVE
STATUS
STATUS
POWER
POWER
MIC
contacta HLD9
CLIP
ACTIVE
MIC
LINE
PHTM
CLIP
CLIP
ACTIVE
ACTIVE
PHTM
LOW SIG
contacta H
LINE
2.5
5
CLIP
PERIMETER
ACTIVE
PRIMARY
D
LOW SIG
SECONDARY
PERIMETER
PRIMARY
SECONDARY
11