DURASONIC DS2L Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Pulitore a ultrasuoni per gioielli DURASONIC DS2L. DURASONIC DS2L 18.

Draining Your Cleaner

Warning

Do not immerse the cleaner in water.

Unplug the cleaner from the power source.

2L, 3L, 4L, and 6L models do not have a drain. To empty, use the side of the rim to

pour the used solution into a waste disposal unit, rinse the tank thoroughly and refill with

new solution.

Cleaning - check the tank for contamination whenever you change solution. If

necessary, remove contaminants with a nonabrasive cloth and water.

Emptying - always unplug the cleaner before emptying the tank. Empty the solution into

a waste disposal unit.

Filling - always unplug the line cord before filling the tank. Fill the cleaner to the

operating level (one inch from the top with beaker/tray in place), using warm tap water.

Low solution level - will cause the cleaner to fail. When you remove heavy or bulky

loads from the cleaner, the solution level may drop below the operating level. If so, be

sure to replace lost solution and degas, if necessary, depending on the amount used.

Overload - do not rest any items on the tank bottom. Weight on the tank bottom

dampens sound energy and will cause damage to the transducer. Instead, use a tray

and/or beaker positioning cover to support all items. Allow at least one inch between the

tank bottom and the beaker or receptacle for adequate cavitation.

Covers - allow the cleaner to heat up faster, to a higher temperature, and avoid

excessive liquid evaporation.

Heater - the heater may cause some discoloration of the tank wall. This is normal and

will not affect the performance of the unit.

Solution - the fastest method to heat your cleaner is to fill with warm solution, use heat,

ultrasonics (which also adds heat), and a cover.

Solution activity - the amount of visible activity is not necessarily related to optimum

cavitation for cleaning.