Durastall 80 Montaggio, installazione, parti di ricambio - Pagina 4

Sfoglia online o scarica il pdf Montaggio, installazione, parti di ricambio per Prodotto idraulico Durastall 80. Durastall 80 6. Shower stall

Stampa la pagina
NOTICE: Extended Base is for use with Mustee free-standing cabinets only! NOT for "built-in" alcoves!

EXTENDED BASE

A.
Check shower base carefully making sure it is not damaged. Refer to the "rough-in" drawing and
determine location of shower base.
B.
Assemble drain to shower base (see illustration) using all washers provided. Do not use any putty or thread
sealant on either drain body or waste fitting. Tighten drain fitting so outlet points in direction of floor drain
when base is set in desired location.
C.
Determine point where 1-1/2" (Drain Kit 82.400A) or 2" (Drain Kit 42.400A) plastic pipe extension (Schedule
40 PVC-DWV not furnished) will go through base side wall and cut opening in side wall as required. Base
material may be drilled out or cut with fine tooth sabre saw or hacksaw. CAUTION: When cutting opening for
plastic pipe be careful not to cut into shower floor area.
D.
Assemble 1-1/2" plastic pipe extension to drain fitting using plastic pipe cement obtainable through your
local plumbing or hardware supply store.
E.
Set base on floor with leveling screws in place. Level unit and connect to floor drain using a plastic
elbow or similar connector.
PARTS ILLUSTRATION
SECTIONAL VIEW
EXTENDED BASE
PARTS LIST
PART NUMBER
KEY
MODEL
MODEL
NUMBER
82
1
72.101
2
70.207
3
42.309
4
42.306
5
32.214
6
42.319
7
32.207
8
82.303
9
72.803
4
DRAIN ASSEMBLY
142
DESCRIPTION
42.1020
Shower Base
40.210
Threshold
42.309
Strainer
42.306
Drain Body
32.214
Sealing Washer - 1/16"
42.319
Sealing Washer - 1/8"
32.207
Fiber Washer
42.313
Molded Waste Fitting
72.803
Leveling Screw (4-Req'd.)
SI-188 (8•07)