Audiovalve ASSISTENT 100 Mark 2 Manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Audiovalve ASSISTENT 100 Mark 2. Audiovalve ASSISTENT 100 Mark 2 18. Integrated stereo triode tube amplifier

Stampa la pagina

Assistent 100 – Mark 2

integrated tube amplifier_

___________

INSTALLATION AND OPERATION

MAIN VOLTAGE

and Main Power Plug ( fuse ) and Main Switch

MAIN POWER connection is via supplied plug-in lead. The standard IEC socket connects

the mains power at the amplifier end while a local mains plug is required at the wall end.

In the event where a "local" plug needs to be fitted to the wall end of the lead, ensure

that the plugs is wired correctly by a suitable qualified or experienced person.

Ensure the amplifier is disconnected from the main voltage before attempting

any modification of the main connection.

The heavy round duty rocker switch for the main voltage ON /OFF is located on the rear

side of the power supply near by the main power connector. The main fuse is next to the

main plug, the value is 3,15 amp sb. for 230V AC or 6 amp. sb as for 117V AC.

DO DISCONNTECT the main power cord from the voltage when you check the fuse !

When the ASSISTENT 100 is switched ON with the the power switch, the display in front

of the amplifier shows the AUDIO VALVE logo in a sleep mode, and the display of the

main power supply is NOT shinning, but the lights in the panel meter glow. So you konw,

the MIAN switch is in poper ON mode. This status shows that the ASSISTENT 100 is

prepared for main power function.

Now you can switch ON the amp by the remote control, press the the power button ON

and you see the front panel will be red shining by LED lights – its the STAND BY mode

too. After a wile from 30 seconds the amp go in the operate mode, the anode plates

become high voltage and the front panel light chance from red to blue or green. Now the

amp ready to play music.

Please switch OFF the main power while leaving the house or sleeping, the red light in

front will be go off !

Make sure that your home voltage is the same as the printed voltage on the lable of the

rear side of the power supply.

Please notice that you never exceed the main voltage in the prescribed value shown on

the lable of the serial number on the rear side.

If you can`t provide the amplifier with the exact shown main voltage, please use

a voltage stabilizer - particulare for the US or Taiwan ( 115 VAC, max. 120 V AC )

and Mainland China market with 230 V AC.

MAIN FUSE

The Mains fuse is fitted in the IEC Main / Line socket on the rear of the power supply.

The fuse must has the value 3,15A for 230 VAC and 6 A for 117 VAC slow blow.

If the fuse keeps blowing up the amplifier must be checked by a professionel technican.

DO NEVER FIT A FUSE WITH HIGHER RATING.