Duratax NITRO DEMON Manuale di montaggio e funzionamento - Pagina 4

Sfoglia online o scarica il pdf Manuale di montaggio e funzionamento per Giocattolo Duratax NITRO DEMON. Duratax NITRO DEMON 20.

❏

1. Remove the Nitro Demon, transmitter and parts

from the box.

❏

2. Remove the twist-tie from the receiver antenna

wire. The receiver antenna wire is a bundled thin wire

that is attached to the receiver. Run the length of the

antenna wire through your fingers to help straighten

the wire out, this will make it easier to insert the wire

through the tube. Remove the antenna tube from the

decal bag. Slide the receiver antenna wire through the

antenna tube. Do not coil or cut the antenna. Cut

two pieces of fuel tubing 1/8" wide and slide them over

the outside of the antenna tube and wire. This is to

help hold the antenna wire on and avoid getting the

antenna wire cut in a roll over. Note the placement of

the tubing on the antenna tube.

❏

3. Remove the air filter parts from the parts pack.

Slide the large rubber O-ring around the threads of the

outer housing. The O-ring will help seal the air filter

housing together. Soak the air cleaner element with an

air filter oil, light machine oil, or, in a pinch, shock oil.

Thoroughly soak the foam element and squeeze out

the excess. Then install the filter element into the

plastic outer housing.

FINISHING THE NITRO DEMON RTR VERSION (DTXD75**)

❏

4. Press the "L" shaped boot onto the bottom housing

of the air filter. Using one of the included tie-straps,

tightly secure the boot onto the bottom housing. Cut off

the excess portion of the tie-strap. Screw the bottom

and outer filter housing together. Note: Overtightening

will strip the threads.

❏

5. Place the air filter onto the carburetor. Using the

remaining included tie-strap, tightly secure the air filter

to the carburetor. Cut the excess portion of the tie-

strap off to avoid interference.

❏

6. Remove the receiver battery holder from the radio

box. Install (4) "AA" batteries (included) into the battery

holder in the configuration molded into the battery holder.