Contax TLA30 Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Camera Flash Contax TLA30. Contax TLA30 11. Modern classic slr series

Stampa la pagina

CONTAX TLA Flash

System Accessories

Wide Panel

Flash >

With the TLA30 you can take flash shots with a 35 mm wide-angle lens. Using the Wide Panel, which is supplied as standard

accessory with the TLA30, you can extend the coverage to accommodate a 24 mm wide-angle lens.

Mounting

the Wide Panel

(1) Insert the tab on right side of the panel and press it against

spring on right side of flash head. (2)Then, press the entire

panel to lock into place.

Removing

the Wide Panel (1) While pressing in direction of arrow against the tab on left side of the panel, (2) pull the panel

toward you.

Effective flash range in TTL and Normal Auto modes, and guide numbers on the Manual mode are affected when using the Wide

Panel because of an increase in angle of coverage. Use the Exposure Computer Dial as directed below to ascertain the correct

exposure,

In the TTL and Normal Auto Modes Rotate and set the Exposure Computer Dial by aligning the Wide Panel index mark " " with

the ASA film speed of the loaded film Then consult the Auto Flash Range Guide to confirm the flash range applicable to the

coverage aperture. In the Normal Auto mode, by rotating the Exposure Computer Dial, align the coverage aperture with either the

red or green index positions marked " ", Then set the extreme right of the Auto Flash Range Guide to either one of the" "

positions.

In the Manual Flash Mode Rotate the Exposure Computer Dial, setting the ASA film speed in use to the Wide Panel index mark

corresponding to the same flash output value used in setting the Flash Mode Selector. Then read out the correct coverage aperture

for the applicable flash-to subject distance and set the aperture accordingly.

< Using the

TLA Extension Cord 100S

When employing the TLA Extension Cord 100S, which is sold separately, the flash unit can be used off camera at different positions

and angles, permitting a variety of special off-camera flash techniques not possible with at-camera flash.

Attaching the Extension Cord Insert the clip-on unit into the camera's accessory shoe and then plug the other end of the cord into

the Extension Cord Socket of the TLA30 and secure by tightening the locking ring. The flash unit can now be charged and flashed

in the off-camera position. And by combining the TLA Multi Connector S, TLA Extension Cord 10OSS and 30OSS, all of which are

sold separately, you can increase the movable working radius of the flash unit for enhanced application. However, the combined

length of the extension cords should not exceed 10 meters.

flash unit's sensor on your main subject.

With the flash unit used off-camera, you can obtain the following effects.

2) Vignetting and uneven lighting which often occur with close-ups may be eliminated by using the optimum angle and position of

the flash for the particular shot. 3) For bounce flash, ft is possible to position the flash unit while taking the lighting effects into

account.

< Using the optional

TLA Multiple Flash System

With the TLA30, you will be able to take multiple flash shots in the TTL Auto mode by using, TLA Multiple Flash System

Accessories (TL-A Multi Connector S, TLA Extension Cords, TLA Extension Connector S, TLA Attachment Adapter),

Modern Classic SLR Series

Contax TLA30 Flash Unit - Instruction Manual

1) For portraits, a pleasing

"three-dimensional" effect may

be produced by holding the flash

unit diagonally off to the side at

an angle pointing down on the

subject. By projecting the flash

in this way, you will be able to

give variation to the subject's

expression and shadow areas.

When the coverage angle is not wide enough for

close-ups, you can eliminate flash light vignetting by

tilting the flash head downward and converting to the

Wide Panel.

When shooting in the Normal Auto flash mode, be sure to maintain