DAPAudio DS-CM-6 Manuale del prodotto - Pagina 11

Sfoglia online o scarica il pdf Manuale del prodotto per Attrezzature per DJ DAPAudio DS-CM-6. DAPAudio DS-CM-6 16.

Stampa la pagina
34. Fader Start B
1/4" jack for remote fader start.
35. Fader Start A
1/4" jack for remote fader start.
36. Channel 3 CD/PHONO Selector
Used to set the input level for the PHL1 Input (48) to either phono or line level.
37. Channel 2 CD/PHONO Selector
Used to set the input level for the PHL1 Input (50) to either phono or line level.
38. Channel 1 CD/PHONO Selector
Used to set the input level for the PHL1 Input (52) to either phono or line level.
39. GND
Use to connect the ground wire of your turntable.
40.
AC Inlet with integrated fuse holder.
This connector is meant for the connection of the supplied main cord. Connect one end of the power
cord to the connector, the other end to the mains, then turn on the power switch to operate the unit.
Note: Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains.
41. Master RCA Unbalanced Out
Use these outputs to connect an amplifier with balanced inputs.
42. Master RCA Unbalanced Out
Use these outputs to connect an amplifier with unbalanced inputs.
44. Record RCA Unbalanced Out
Use these to connect a recording device.
45. Channel 4 L2 RCA Input
Use to connect a line level device.
46. Channel 4 L1 RCA Input
Use to connect a line level device.
47. Channel 3 L2 RCA Input
Use to connect a line level device.
48. Channel 3 PHL1 RCA Input
Use to connect either a phono or line level device depending on the position of the Channel 3 CD/
PHONO switch (36).
49. Channel 2 L2 RCA Input
Use to connect a line level device.
50. Channel 2 PHL1 RCA Input
Use to connect either a phono or line level device depending on the position of the Channel 2 CD/
PHONO switch (37).
51. Channel 1 L2 RCA Input
Use to connect a line level device.
52. Channel 1 PHL1 RCA Input
Use to connect either a phono or line level device depending on the position of the Channel 1 CD/
PHONO switch (38).
53. MIC 2 Jack Unbalanced Input
MIC 2 channel ¼" unbalanced microphone input.
Replace the fuse only with a fuse of same specification (T250mA).
9