DAQ system NET-AIO11 Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Hardware del computer DAQ system NET-AIO11. DAQ system NET-AIO11 12.

Stampa la pagina
Read from Lib
10
Buffering WR Pointer
Buffering RD Pointer
11
View Scale
12
Offset
13
Set
14
Sample Rate
15
Set
16
0x
17
Digital Out
18
Digital In
19
IP Address
20
MAC Address
21
SUB-NET MASK
22
GATE WAY
23
Port Number
24
PROGRAM
25
sec
26
Delay + Store
27
Data READ
28
RAM LOAD
29
FIND
30
FIND EMIF.BIN
board.
It displays that the number of data bytes of read from the library
buffer in application.
It displays a saving pointer of library buffer.
It displays a reading pointer of library buffer.
A scaling factor displays on the graph.
It is an offset to set the up/down position of graph.
View Scale and Offset is applied to the graph.
It selects an Analog data sampling rate.
It sets the Sampling rate.
It enters the digital output value.
It sets the digital output value.
It confirms the Digital Input value.
Displayed Data, the value of low 0~7 bits are a DIN value, and
8~11 bits value are setup value of DIP switch.
It enters an IP address to be stored the board.
It enters a MAC information to be stored the board.
It enters a MASKING information to be stored the board.
It enters an address of Network Gateway to be stored the board.
It enters a port numbers to be stored the board.
The section of 20~24 saves in the flash memory.
The stored data will be reflected in the firmware when the board
is reset. Be careful of the confliction to set the same information.
This function is only available with the USB interface, so No. 2)
"USB" selection and this function can use when the No. 6) "SEL"
run.
It enters a delay time of Delay Mode Data collection.
After a delay time of Delay Mode, it executes a data collection.
It reads a data that is collected in the Delay Mode.
When you run it that is not the end of delay and data collection,
the Beep sound occurs. Otherwise, the data is displayed on the
right side of the graph.
At right in the path of the editor, USB booting binary loads the
device. First, the running mode should be selected as the USB.
It searches the USB load image.
It searches an execution image to be stored in the flash memory.
10-
-
NET-AIO11 User's Manual (Rev 1.0)
http://www.daqsystem.com