Duratuf GG99 Manuale di istruzioni per il montaggio - Pagina 15

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Deposito all'aperto Duratuf GG99. Duratuf GG99 16.

SECURING SHED

TIMBER PEGS—WOODEN FLOOR

• The optional Duratuf Timber Peg Down Kit includes six H5 treated timber

pegs that can be hammered into the ground and then attached to the

Base Plate with stainless steel screws. A Guardian timber floor can then

be fitted on top of the Base Plate if required.

BOLT DOWN KIT—CONCRETE

• The optional Duratuf Bolt Down Kit includes 6 x galvanised

brackets, screws and dynabolts.

• Space the brackets evenly around the shed and fix to the Bottom

Plate and the concrete slab. A 10mm masonry drill bit is required.

FITTING A GUARDIAN FLOOR KIT (OPTIONAL)

• Position the Floor Joists centrally between the side

Base Plates and skew nail each end with two 75mm

nails.

• Check that the shed is sitting level and square . Check

that the diagonal Bottom Plate measurements are the

same. This ensures that the shed base is square.

• Place the Floor Boards in position. (You may need to

cut the last Floor Board to the correct width using a

Skill Saw.) Nail each Floor Board in, using two 50mm

nails each end and two nails into each floor joist.

FIT FRONT PADBOLT

• Rivet Padbolt to door and keeper onto Door Side as

shown.

FIT BACK PADBOLT

•

Rivet back pad bolts to pad bolt supports then rivet pad bolt sup-

ports to back of small door (Top and bottom)

•

Using 10mm drill bit, drill hole into top and bottom timber plates

IMPORTANT— CLEAN UP

REMOVE ALL DRILL FILINGS FROM ROOF, WALLS AND CHANNELS THOROUGHLY.

FAILURE TO DO THIS WILL RESULT IN CORROSION AND COULD THEREFORE VOID THE WARRANTY

YOUR DURATUF GUARDIAN SHED IS NOW COMPLETE. RELAX......

Secure your shed using Treated Timber Pegs or a Bolt Down Kit

BACK BASE PLATE

JOIST

FRONT BASE PLATE