Duratuf Kiwi MK1 Manuale di istruzioni per il montaggio - Pagina 5
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Deposito all'aperto Duratuf Kiwi MK1. Duratuf Kiwi MK1 16.

Note:
For sheds with the Raised Floor Modification option the studs will be 1.780m long to allow the Wall Sheets to pro-
trude 20mm below the Bottom Plate. Refer to Raised Floor Modification section (Page 15).
Note:
Studs and Nogs surrounding a window opening are to be fitted once the wall cladding is nailed in place.
Step 1: Back Wall: Select one 1.715m Base Plate
(Green), one 1.715m Top Plate (Red) and two
Studs (Yellow). Lay out Plates and two Studs on
a flat surface and nail together using two 75mm
nails per join. Position 1.625m Nog .883m down
from Top Plate and nail in place.
Step 2: Front Wall: Select one 1.715m Base Plate
(Green), one 1.715m Top Plate (Red), three
Studs (Yellow) and a .785m Nog. Nail studs to
each end of Plates. Nail in remaining stud us-
ing .785m Nogs to get correct position. Position
Nog .883m down from Top plate and nail in
place.
Step 3: Select two 1.715m Base Plates (Green) and two
1.715m Top Plates (Red). With front wall lying on
the ground, nail Plates to frame. Ensure Green
joins to Green and Red joins to Red.
Step 4: Position the back wall frame on top of plates.
While someone supports frame, nail in place.
Step 5: Carefully roll frame over onto its base. (Pieces of
timber from the packaging may be used to tem-
porarily brace the frame before rolling it over).
Position 1.625 End Wall Nogs .883m down from
Top Plate and nail in place. If fitting a Kiwi Floor,
fit Floor Joists now. Place joists equally and nail
in place using three 75mm nails per end.
Step 6: Position a Jack Stud centrally on 1.715m End
Wall Top Plates and skew nail in place with two
75mm nails per Jack Stud. Position Ridge Beam
centrally on Jack Studs and skew nail in place
using two 75mm nails each end. Pre-drilling
holes before nailing will prevent timber from split-
ting.
MK1 TIMBER FRAME
1
2
3
4
5
6
5