Duratuf KIWI MK2A Manuale di istruzioni per il montaggio - Pagina 11
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Deposito all'aperto Duratuf KIWI MK2A. Duratuf KIWI MK2A 16.
Anche per Duratuf KIWI MK2A: Manuale di istruzioni per il montaggio (18 pagine)
Stampa la pagina
MK2A CLEAR ROOF PANEL (Optional)
Step 1: Leave a gap where the Clear Panel is to be fitted. Position the next Roof Sheet. Ensure it overlaps correctly, then
rivet together, one rivet in the centre and one approximately 600 mm down from the centre on both sides. Rit re-
maining Roof Sheets, overlapping and riveting as you go. Nail on first Roof Sheet (refer step 3 on page 10).
Step 2: Where the Clear Roof Panel is to be positioned, nail a 45x45mm Bevelled Edge Support on each side of the
Ridge Beam. (fig. 1)
Step 3: Position Clear Roof Panel and Flat Roof Sheet (or second Clear Panel). The Flat Roof Sheet underlaps one sheet
and overlaps the other. The Clear Roof Panel OVERLAPS both Roof Sheets. Ensure sheet joins are flush at the
outside edge then rivet flat sheets to pressed sheets, three rivets per join. Centralise Roof at the other end and
nail in place.
Step 4: Ensure Ridge Beam is straight, then nail the Clear Panel and Flat Roof Sheet (or second Clear Panel) to
45x45mm Bevelled Edge Supports using one 30mm Clout per Pan. Run two generous beads of Silicone on the
under side of the Pressed Capping Sheet. Position Pressed Capping Sheet on Ridge Beam and nail in place us-
ing three 40mm Weatherseals. Nail one 40mm Weatherseal into Ridge Beam beside each overlap (one nail per
sheet).
Step 5: At the Back set up a String line in the centre of the Top Plate. Ensure Top Plate is straight and nail off, one 40mm
Weatherseal per Pan. Repeat at the front.
Note:
When nailing through the Clear Panel, pre-drill a 6mm hole.
30mm CLOUT
SILICONE
FLAT ROOF
SHEET
45 x 45 BEVEL
EDGE SUPPORT
WEATHERSEAL NAIL
PRESSED
CAPPING SHEET
75mm NAIL
RIDGE BEAM
JACK STUD
TOP PLATE
11
CLEAR ROOF
PANEL
PRESSED
ROOF SHEET
Note: MK2 shown