DuraVent PolyPro Flex Series Manuale di istruzioni per l'installazione - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Ventilatore DuraVent PolyPro Flex Series. DuraVent PolyPro Flex Series 12. Polypro double-wall flex gas vent system for category ii & iv gas-burning appliances

Stampa la pagina

B VENT RELINE:

From within the room where the appliance is located, remove any existing horizontal or angled

sections of B Vent. PP Flex cannot be installed at an angle greater than 45 degrees from vertical.

The B Vent Adapter-Lower will fit over the bottom of the existing B Vent's vertical stack at or

near the ceiling. Carefully inspect the B Vent to ensure integrity. Ensure any visible screws or

obstructions are removed. PP Rigid pipe must be used to complete install to the appliance-

Instructions- 2" (60mm) PP Flex in B Vent

1. Remove existing B Vent termination cap

2. Carefully feed flex down through B Vent so

approx 2' of flex extends beyond the bottom

of the B Vent (Flex puller or rope aid optional)

3. Cut to length the top of Flex pipe and

insert flex through B Vent Adapter- Upper, and

through the Termination Base.

4. Install the PP Flex Gasket and Flex Female

Adapter onto Flex pipe using instructions in

previous pages.

5. Lower the B Vent Adapter- Upper onto the

top of the existing B Vent and secure using

screws (x3) supplied with the hardware kit.

6. Attach the Termination Top to the

Termination Cap (clicks when engaged),

then insert the Flex Female Adapter into the

Termination Cap. Push the assembly onto the

Termination Base (clicks when engaged, see

Fig.12).

7. Push the completed assembly down onto

the B-Vent Adapter- Upper. When level, secure

with three screws provided.

8. At the bottom end, cut the PP Flex to

length 3" below the bottom of the vertical B

Vent still portruding from the ceiling.

9. Install the Flex Gasket

and Flex Male Adapter onto

the Flex pipe

10. Install B Vent Adapter-

Lower. (Flex Male Adapter

should protrude beyond

per Fig.13)

11. Secure the B Vent

Adapter- Lower to the B

Vent using three screws

from the supplied

hardware.

(CLICK!)

Figure 12

TERMINATION TOP

TERMINATION CAP

FLEX FEMALE ADAPTER

2" (60MM) FLEX GASKET

2" (60MM) FLEX

TERMINATION BASE

MOUNTING HARDWARE

B VENT ADAPTER- UPPER

B VENT PIPE

2" (60MM) FLEX GASKET

FLEX MALE ADAPTER

MOUNTING HARDWARE

B VENT ADAPTER- LOWER

Figure 11- (2" Flex / B Vent)