DuraVent Hepa Tower Manuale di installazione e funzionamento - Pagina 4
Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Sistemi di filtrazione dell'acqua DuraVent Hepa Tower. DuraVent Hepa Tower 12.
Stampa la pagina
START-UP AND OPERATION
Before starting this Fan for the first time, verify that:
1. The HEPA Tower is standing on its wheels
2. The HEPA Tower's power cord has been plugged into a ground tested, 120-volt outlet with
uninterrupted power.
3. The area in front of the towers inlet (grille) is as unobstructed as possible.
4. The Air Exit Louvers have been adjusted for proper Air Direction (see operational tips)
When running the HEPA Tower for the first time, make sure to observe it turning on, running at all of its
speed settings, and turning off, also verify Timer works at 1 Hour Setting.
As shown above, there are four "buttons" on your fan's control interface:
When the Digital Touch Controller (DTC) is connected to power, a red LED will illuminate.
See the Power Indicator shown above.
The DuraVent Unit has ten speed settings. Turn on the fan by touching FAN UP or TIMER UP. The fan will
start at minimum speed. Green LED's will illuminate to indicate the speed setting.
If the Fan was turned on by TIMER UP, the timer will be set to one hour and blue LED's will illuminate to
indicate the timer setting. Press or hold FAN UP to increase the fan's speed to maximum. Press or hold
TIMER UP to increase the length of time the Fan stays on in one hour increments until the desired time,
or the maximum time of 12 hours, is achieved.
If the fan is already operating at minimum speed, touch FAN DOWN/OFF to turn off the fan; any time
remaining on the timer will be canceled. If the fan is at maximum speed, press or hold FAN DOWN/OFF
to decrease the speed to minimum and once again to turn the fan off.
Press or hold TIMER DOWN/CANCEL to reduce the time on the timer by one hour increments until the
desired time is achieved or the timer is canceled. When the timer expires, the fan will turn off
automatically. If the timer is canceled, the fan will remain on at its current speed.
* Note: If untouched after a moment the selection LED's will dim.
** Note: If the Fan is on without a timer, the fan will run indefinitely.
HEPA TOWER Installation and Operation Manual, 03-15-2021
DuraVent ®, Inc., 2021. All Rights Reserved.
Page 4