Addonics Technologies AE6CFHI Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Accessori per computer Addonics Technologies AE6CFHI. Addonics Technologies AE6CFHI 8. Cf or cfast drive

Stampa la pagina

Setting or Modifying the RAID Mode Using the JMicron

HW RAID Manager Utility Program:

For Windows users, install the JMicron HW RAID Manager located on the

SATA Controller CD. In the CD, go to Configuration Utilities > JMB393. This

manager can be use to create and monitor the status of the RAID volume.

It is recommended to use the default factory RAID DIP switch setting when

using the JMicron HW RAID Manager.

Modify the RAID mode on the 5-port HPM-XA using DIP switch

Recommended to be used on operating system without JMicron HW RAID

Manager support like Linux, Mac & Solaris. Windows users can also use the

procedure below.

Note: Steps A to D need to be performed each time the raid mode is modified.

Set the DIP switch as shown below.

SW1

Press the RAID setting button with a ball point pen.

While pressing the RAID setting button turn on the system power

where the HPM is connected. The buzzer will sound while holding the

RAID setting button. Release it after at least 5 seconds for hardware

initialization. A single beep will be heard to indicate initialization is

completed. The above steps act as a reset.

Power off the system power.

www.addonics.com

BZS EZ M2 M1 M0

Technical Support (M-F 8:30am - 6:00pm PST)

Phone: 408-453-6212

Email: www.addonics.com/support/query/