4B Shade 2 Manuale di installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di installazione per Automobile Accessories 4B Shade 2. 4B Shade 2 8.

Stampa la pagina
4B SHADE II
Thank you for purchasing the
'Self Supporting Awning'.
4B Shade
We trust your
weather protection.
Please take the time to read through all the installation instructions provided
prior to installation.
Should you require any assistance – email
detailing your enquiry.
Best regards
Ralph Longley

CASSETTE INSTALLATION

1
Disassemble cassette by first removing the 2 micro screws then 'Carefully' lifting each end of the Cassette
front section. (A)
NOTE: The Cassette front section is held by 2 internal plastic lugs which can break if too much force is
used. Push down gently as you lift each side upwards.
2
Carefully remove the fabric by lifting the pin on the LHS using the 'Tensioning Tool' (A).
Store the fabric ready for re-installation later.
Mounting Cassette to the Roof Bars or direct onto Outer Tubes.
3
Mounting on Roof Bars - Remove roof bar and centre the Cassette base onto the rear roof bar.
Mounting on Outer Tube – position outer tubes onto roof bars / rack first – see below and page 3.
HINT – Position the rear roof bar as far to the back of the vehicle as possible for easier operation.
Hint – Remove part of the rubber from the roof bar for a better fit.
4
Drill 3 holes (6mm bit) spaced equally apart through the Cassette back and the roof bar.
•
Secure using the M5 20mm bolts, washers and locking nuts provided.
•
Position Roof Bar back onto rear of the vehicle.
POSITIONING OUTER TUBE BARS
NOTE
– Outer Tube bars must be 'Exact' distance apart front and back! (See page 3)
5
Protect roof with appropriate fabric covers to avoid scratches and other damage.
6
Position each Outer Tube with the end lip in line with the back of the Cassette back.
7
Position bars approx 850mm apart. NOTE – must be equally spaced and centred.
8
Position the Support U Brackets (B)
9
Hint – REMEMBER – the bars must be 'Exact' distance apart front and back! CROSS CHECK.
9
Secure the Support brackets to the underside of the roof bars - (6mm Drill Bit) using the M5 20mm
bolts, washers and locking nuts provided.
10
Insert the Inner Tube bars with the pre drilled hole facing upwards - check they slide freely.
Optional Installation positions for Roof Bars.
4B Cassette
Top Mount.
4B Shade MK II
will provide you with many years of shade and
Installation
Roof Bars and Roof Rack
.
4B Cassette
Rear Mount.
.3.
, the original
A
B
Additional 2 U Brackets
RECOMMENDED
and fixtures (6) required
If fitting Cassette (1)
direct onto Outer Tubes (7)
4B Cassette
Direct onto Outer Tube.