APLOS R0-N5050 Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Sistemi di filtrazione dell'acqua APLOS R0-N5050. APLOS R0-N5050 20. 5 stage reverse osmosis drinking water system, 50gpd

Stampa la pagina

6. Installation Steps

Shut off water supply in your kitchen or whole home and open water tap

where you are about to install the system (on your kitchen sink) for 1 min-

ute to relieve pressure in the system, and then close it.

Screw the feed water adapter 4 into the cold water plumbing. Screw the

feed valve 5 into the feed water adapter 4. To help prevent water leaks use

plumber sealing tape.

Unscrew the compression nut from the feed valve 5 and put it on the red

tube. Push the red tube on the end of feed valve's fitting and screw on the

compression nut. Connect the free end of the red tube with the quick con-

nect fitting of the first (rightmost) housing in the rack.

Connect the drain saddle 8 with drain pipe from the kitchen sink. The drain

saddle is compatible with most standard drain pipes. Drill a hole of 5.0

mm (0.2") diameter in the kitchen sink drain pipe, apply rubber gasket

with sticky base (included in the package). Install the drain saddle 8 on the

drain pipe over the hole. Tighten screws on drain saddle with a screwdriver.

Insert black tube into the connection on the clamp (figure 4). Connect the

other end of the black tube with concentrate outlet of membrane housing.

CAUTION! Check if the flow regulator 12 is installed in the black tube in

the end connected to membrane housing.

Add 5-6 wraps of plumber tape to tank knob and hand tighten tank valve –

do not overtighten. Close the tank valve.

IMPORTANT! Check air pressure in empty tank. Tank should be pressur-

ized to 0.4-0.6 bar (5.8-8.7 psi). If necessary, use a pump with a pressure

gauge to increase the pressure or push the core of the valve stem to

relieve pressure.