Apogee QUICK DRAW Manuale - Pagina 7
Sfoglia online o scarica il pdf Manuale per Giocattolo Apogee QUICK DRAW. Apogee QUICK DRAW 12.
Stampa la pagina
1-2. Using a section of aluminum angle or a door frame
to ensure alignment, draw a line along the length of the
motor mount tube and mark 5/8" (16mm) from the aft
(hardened) end of the tube. Once marked, sand the inner
edge of the tube (if hardened in step 1) to ensure easy
motor installation.
1-3. Using a sharp hobby knife, remove the plywood parts
from the sheet (P/N 12710). Keep the L tabs inside the
rings as well.
1-4. With the label of ring A (the latch ring) facing toward
you, chamfer the right edges of the tabs as shown using
a flat needle file. The chamfer does not need to go
through the entire thickness. It is simply there to make it
easier to align the finished removable mount into the fixed
mount.
1-5. Using wood glue, glue the alignment frames into the
forward centering ring (ring C) as shown. All mating sur-
faces, including the faces and interior of the slots, should
have glue applied so that the final latch assembly has
maximum strength.
1-6. Rotate ring C around, so the alignment pins are facing
you. Apply wood glue to the ring and pins and install the
latch spacer (ring B) with the shock cord notch aligned on
both rings. Remove any glue that has squeezed out.
1-7. Apply wood glue to the latch spacer (ring B) installed
in the last step and to the alignment pins. Install ring A
(the latch), making sure that the chamfers created in step
4 are facing inwards toward the forward centering ring
(ring C) and the shock cord notches are aligned on all
three rings. Clean any glue from the outside of the latch
area and set the latch assembly aside to dry.
1-8. Wood glue the L-shaped tabs into the aft centering
ring (ring D) with the rounded ends passing through the
slots as shown and set the assembly aside to dry.
5/8"
Step 1-2
16mm
Step 1-3
Step 1-4
Step 1-5
Step 1-6
Ring B
Step 1-7
Ring A
Step 1-8
Ring A
Ring C
Ring C
Page 7