Apogee Skill Level 4 Manuale - Pagina 7

Sfoglia online o scarica il pdf Manuale per Giocattolo Apogee Skill Level 4. Apogee Skill Level 4 16.

Apogee Skill Level 4 Manuale
… 25. Apply wood filler to the fins and once it has
dried, sand the fins smooth with a fine grit sandpa-
per to reduce visible wood grain.
… 26. Cut out eight of each of the main fin detail
pieces - parts marked "A" (angle adjustment
blocks) and "B" (mounting flanges) – from the
cardstock sheet using a sharp hobby knife (two
extra of the smaller "A" details are provided on the
sheet).
… 27. Clean up each detail piece by sanding the
remains of any tabs off of the edges using a fine
grit sandpaper. Aggressive sanding can cause the
cardstock to split and lead to soft edges, so a 400
grit sandpaper and minimal pressure is recom-
mended.
… 28. Apply a thin film of wood glue to each of the
"B" detail pieces and glue them into place flush
with the root and back slope of the fin on each
side of the fin. Repeat for the remaining 3 fins,
applying the remaining six "B" detail pieces in this
way.
… 29. As in the last step, apply wood glue to the "A"
detail pieces to each side. Align the stepped inset
of the cardstock piece with the matching steps in
the root edge of the main fins. The aft corner of
the "A" pieces should end up roughly 5/8" (12mm)
from the step in the root edge of the fin. Repeat for
the remaining three fins. Once all eight "A" pieces
have been attached, allow the wood glue to dry.
Step 25
Step 26
Step 27
Step 28
Step 29
Remove Remnants
of Tabs
Edges are Flush
at Corner
5/8" (12mm)
Page 7