Dasan DA911W Manuale d'uso - Pagina 5
Sfoglia online o scarica il pdf Manuale d'uso per Ricevitore Dasan DA911W. Dasan DA911W 7. 2.4ghz fhhs digital
Anche per Dasan DA911W: Manuale d'uso (7 pagine)
Stampa la pagina2.4GHz FHHS DIGITAL Transmitter/Receiver
MODEL: DA911W
6. Do not attempt to rejuvenate the battery provided with or identified for use with this product by heating them.
Sudden release of the battery electrolyte may occur, causing burns or irritation to eyes or skin.
7. When inserting the battery into this product, the proper polarity or direction must be observed. Reverse
insertion of battery may result in leakage or explosion.
8. Remove the battery from this product if the product will not be used for a long period of time (several months
or more) since during this time they could leak in the product.
9. Discard the "dead" battery as soon as possible since "dead" battery is more likely to leak in a product.
10. Do not store this product, or the battery provided with or identified for use this product, in high-temperature
areas. Battery that are stored in a freezer or refrigerator for the purpose of extending shelf life should be
stabilized at room temperature prior to use after cold storage.
11. Always disconnect all telephone line cords from the wall modular jacks before installing or replacing the
battery.
CARTON CONTENTS
DA911W DOCKING STATION and TRANSIMITTER AND MIC units
User's Manual, Warranty and Safety Information
Li-ion 1200mA/h 3.6V battery
Warranty card
INSTALLATION
HOW to Install the Battery
1. Remove the battery compartment cover of the transmitter by sliding it down.
2. Insert the Li-ion battery pack into the battery compartment by sliding it up.
NOTE : The battery must be fully charged at least 12 hours before initial use.
Please refer to the "Charging the Battery (Full Charge)" section.
POWER CONNECTION
CAUTON : You must use a 120Volt AC/9-12Volt DC adaptor that delivers
at least 500mA ~ 1A for charger.
The plug must correctly fit the machine's DC 12V jack.
1. Plug the AC Adaptor into a standard AC outlet.
2. Plug the adaptor plug into the DC 12V jack on the rear of the docking station.
CHARGING THE BATTERY (FULL CHARGE)
1. Once the docking station has power connection, place the transmitter in its cradle on the docking station.
2. Leave the transmitter on the cradle for at least 12 hours for a full charge.
NOTE : The battery is continuously charged when the transmitter is on the cradle of the docking station.
DASAN Electron
USA VERSION