APOINT ACNP0120C Manuale tecnico - Pagina 7

Sfoglia online o scarica il pdf Manuale tecnico per Telecamera di sicurezza APOINT ACNP0120C. APOINT ACNP0120C 14. Video conferencecamera sd version; hd version

Stampa la pagina

APOINT VIDEO CONFERENCE CAMERA SECTION

Connections

SD Camera

HD Camera

Installation precautions

Check if the installation location is of sufficient height. Make sure installation spots (ceiling or wall) is of

sufficient strength to support camera and bracket without immediate danger of falling.

Avoid, during both the installation and the normal use, to rotate the camera with the hands and do not

move up and down manually the camera lens; this may damage the normal behaviour of the engine.

Please comply with RS485 wiring standards and select proper RS485 cable. Improper cable may result in

RS485 communication transmission error, which may cause an improper functioning of the camera itself.

Communication protocol and IR channel setup

To set communications parameters, dip switches of the block SW2 are available at the bottom of the

camera. Remembered that the standard use with NexusPub requires to set PELCO D protocol with baud

rate 9600 and that the use of the IR remote controller is recommended during the setup phase, here

there are the instruction for acting on the dip switches of block SW2

SD Camera

NexusPub has been realized with technological contribution of

1. Composite Video Output

2. IR Receiver

3. VISCA IN connector (not used in NexusPub)

4. VISCA OUT connector (not used in NexusPub)

5. S-Video (provisional)

6. DC IN 12V Connector

7. Terminal for RS-422 and RS-485

1. HDMI and HD-SDI Video Output

2. IR Receiver

3. VISCA IN connector (not used in NexusPub)

4. VISCA OUT connector (RS485 connection in NexusPub)

5. DC IN 12V connector

1. PIN 1 OFF AND PIN 2 OFF= IR ADD. 0;

PIN 1 ON AND PIN 2 OFF= IR ADD. 1;

PIN 1 OFF AND PIN 2 ON= IR ADD. 2;

PIN 1 ON AND PIN 2 ON= IR ADD. 3

2. PIN 3 OFF AND PIN 4 OFF= PELCO P;

PIN 3 ON AND PIN 4 OFF= PELCO P;

PIN 3 OFF AND PIN 4 ON= PELCO D;

PIN 3 ON AND PIN 4 ON= VISCA

3. PIN 5: OFF= baud rate 4800 bps; ON=

baud rate 9600 bps

4. PIN 6: OFF= RS-422 and RS-485; ON=

RS-232C

rev.10.2_010717