Apollo Healthcare Technologies Limited APH059 Manuale d'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature mediche Apollo Healthcare Technologies Limited APH059. Apollo Healthcare Technologies Limited APH059 12. Dynamic replacement mattress

Stampa la pagina

INSTALLATION

Step 1 Place the mattress flatly on the bed frame.

The inflation tube should be towards the foot end so that it can be connected to the

inflation nozzles on the pump. See figure below for reference.

Step 2 Cover with a cotton sheet to avoid direct skin contact and reduce friction.

Step 3 Hang the pump over the frame or board at the foot end of the bed.

Make sure the pump is secured.

Step 4 Connect the inflation tubes from the mattress to the pump's inflating nozzles.

Make sure they are properly attached.

NOTE！！

Make sure the air hoses are not kinked or tucked under the mattress.

Also check to ensure the CPR valve is properly attached.

Step 5 Plug the power cord into an electrical outlet with AC230V/50Hz output.

The plug is used as the disconnection device from the mains supply. The plug should

be positioned for easy access. The power cord shall be kept away from the patient to

prevent injuries such as strangulation.

@NOTE: B

EFORE INSERTING THE PLUG INTO THE OUTLET

COMPATIBLE

Step 6 Turn on the power by pressing the power switch at the right side of the pump.

Proceed to the Operation section.

Step 7 Make sure to disconnect the pump by unplugging the power cord when it is not

i n use.

MAKE SURE THE VOLTAGE IS

OPERATION

General

This product is designed to provide maximum comfort to home care patients. Make sure that

you operate this product in a proper way to optimise its value. Here we provide some general

information you should be aware of.

For products:

DO NOT use another pump with different specifications. It is dangerous to

use a pump with pressure capacity greater than 120 mmHg. This may result

in cell-puncture.

DO NOT change any component by yourself. If there is need for

replacement or repair, always contact your local dealer or service center.

For patients: When the Normal Pressure indicator (green) comes on to indicate that the

pressure has been adjusted to a desired level of firmness, the patient can

then lie on the mattress.

Please cover the mattress with a cotton sheet to avoid direct skin contact

and for the patient's comfort.

A firm surface will make it easier for the patient to transfer or reposition.

Make use of the static mode function. It can support the patient by keeping

the mattress from bottoming out when the patient is in a sitting position. See

figure below.

Hand check:

Check if the pressure is properly adjusted by sliding one hand between the

air mattress and the foam base (or bed frame if there is no foam base) to

feel the patient's buttock.

Users should be able to feel the space in between, and the acceptable

range is approximately 25 to 40 mm (1" to 1-1/2"). This hand check

procedure is issued by AHCPR.

Always read the operating instructions before use.