Aponorm Basis Control Manuale di istruzioni per l'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Monitor della pressione sanguigna Aponorm Basis Control. Aponorm Basis Control 19.

Stampa la pagina

5. Traffic Light Indicator in the Display

The bars on the left-hand edge of the traffic light

display

show you the range within which the

indicated blood pressure value lies. Depending on

the height of the bar, the readout value is either

within the optimum (green), elevated (yellow), too

high (orange) or dangerously high (red) range. The

classification corresponds to the 4 ranges in the

table as defined by the international guidelines

(ESH, AHA, JSH), as described in «Section 1.».

6. Data Memory

This device automatically stores the last 30 measure-

ment values.

Viewing the stored values

Press the M button

switched off, to show the last stored value.

Pressing the M button

previous value. Pressing the M button

tedly enables you to move from one stored value

to another.

Memory full



Pay attention that the maximum memory capa-

city of 30 memories is not exceeded. When

the 30 memory is full, the oldest value is

automatically overwritten with the 31st

9 9

briefly, when the device is

again displays the

repea-

value. Values should be evaluated by a doctor

before the memory capacity is reached –

otherwise data will be lost.

Clearing all values

If you are sure that you want to permanently remo-

ve all stored values, hold down the M button (the

device must have been switched off beforehand)

until «CL» appears and then release the button. To

permanently clear the memory, press the M button

while «CL» is flashing. Individual values cannot be

cleared.

7. Battery Indicator and Battery

Change

Low battery

When the batteries are approximately ¾ empty the

battery symbol

will flash as soon as the device

is switched on (partly filled battery displayed). Al-

though the device will continue to measure reliab-

ly, you should obtain replacement batteries.

Flat battery – replacement

When the batteries are flat, the battery symbol

will flash as soon as the device is switched on

(flat battery displayed). You cannot take any further

measurements and must replace the batteries.

aponorm