AddSecure IRIS-4 2 Series Manuale rapido di installazione e manutenzione - Pagina 5

Sfoglia online o scarica il pdf Manuale rapido di installazione e manutenzione per Sistema di sicurezza AddSecure IRIS-4 2 Series. AddSecure IRIS-4 2 Series 9.

Stampa la pagina

IRIS-4

2 Series

Quick Installation and

Maintenance Guide

6.6. Pin Inputs

The IRIS-4 2 Series dialler has four pin inputs that

can be used to generate messages . These can be:

• Text messages via SMS

(IRIS-4 200 & 240 2/3/4G) .

• SIA, Contact ID or Fast Format alarm messages

over IP to the Monitoring Centre .

Note: You can also use the Pin alarm inputs when

directly connected to an alarm panel via the dial

capture, serial or RS485 connections.

Via Open/Close Contact Source

Each pin input is designed to be connected in a loop

via an open/close contact source from an alarm pan-

el, or other device, to a reference ground pin available

on the IRIS-4 2 Series dialler, as shown .

Opening the contact (i . e . loop is open circuit) gen-

erates an alarm signal . Closing the contact generates

the equivalent restore signal .

Via Sense Resistors

It is also possible to link the contacts to the IRIS-4

2 Series dialler via sense resistors so that an open or

short circuit tamper on the loop is detectable and the

Monitoring Centre alerted . In this case, the connec-

tions made should be .

Note:

For this feature to work correctly it is essential to

connect the resistor at the contact end of the loop

and not the dialler end. The Monitoring Centre

must also enable the monitoring of this facility on

the dialler within the IRIS Secure Apps receiving

system.

6.7. Switch on and Calibration

To confirm power is applied, look for the indicator

'SYS LED' flashing yellow light on the IRIS-4 2

Series dialler board . Once powered on you will have

a brief window to recalibrate the touch screen if

required, press the 'Touch Calibration' box at the

top of the screen and follow the onscreen prompts .

For more information, see Section 7 . 5 "Touch Screen

Calibration" .

6.8. Configuration

To configure the dialler, use any of the following

methods:

• Touch screen.

• Alarm panel integration e.g. Honeywell Galaxy

(RS485 connection) .

Note: Please configure the alarm panel first for

connections to Honeywell Galaxy RS485 integra-

tion, as these will transmit configuration to the

IRIS-4 2 Series dialler.

For more details on the alarm panel integration,

download the full panel installation manual from

http://www.addsecure.com.

• Connect the board's Micro USB connector to a

laptop/PC running the IRIS Toolbox software .

Download the IRIS Toolbox user guide from

http://www . a ddsecure . c om .

Defaulting

If at any point a complete default of the dialler is

required, use the following procedure:

1 . Enter the Installer menu on the dialler touch

screen and enter the installer password .

2 . Go to the 'Settings' option and scroll down

with the scroll bar on right until you see option

for 'Default All' .

3 . Enter the 'Default All' and confirm that the

dialler is to be defaulted .

Configuration via Touch Screen

IRIS-4 2 Series can be configured directly using the

on board touch screen with the supplied stylus .

Enter the default installer code: 111111 and then

click 'OK' .

You will be prompted to change the password, please

record the new password .

Enter and confirm a new password and press 'Save' .

The Main Menu is displayed .