Duro Dyne 27182 Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Apparecchiature industriali Duro Dyne 27182. Duro Dyne 27182 16. Rolling head pinspotter

INSTALLATION INSTRUCTIONS

1) For the Mach 70-

Connect the Power Pack to a source of 208-240V 60 Amp. power. This service should be connected to

a 60 amp disconnect box fitted with 60 amp slow blow fuses. The Power supply line to the power pack

pigtail should be #6 (or heavier) wire to minimize voltage losses. The black and white wires are the power,

the green is ground. Select 208V or 240V at the voltage switch in the console on left leg to the closest

match to the power supply voltage.

2) Attach the Actuator Arm to the socket on the top of the Trolley.

3) Connect the air line to the Regulator. Adjust the regulator pressure to 80-85 PSI.

4) Plug the Vibrator Power Plug into the socket on the rear of the Control Panel.

Mach 70 INITIAL ADJUSTMENTS

1) Turn the power switch to "ON".

2) Turn the vibrator switch to "ON".

3) Add the weld pins to the hopper (Vibrator Bowl).

4) Adjust the vibrator speed so that the weld pins climb the spiral track inside the vibrator bowl without

vibrating off.

5) When the weld pins fill the track up to the Vibrator Sensor, the vibrator automatically shuts off.

6) Flip the HEAD TEST Switch to either the "WELD #1" or "WELD #2" position.

NOTE: The Rolling Head Mach 70 Pinspotter has two redundant weld circuits. In the event that the solid

state relay controlling the weld fails you may simply flip the switch to the other circuit and continue

production. A replacement Weld Relay should then be ordered through your local Duro Dyne wholesaler.

STARTING OPERATION

1) Never actuate the unit without metal over the mandrel or lower copper ground bar. For maximum weld

quality, the metal should be in flat contact with the ground bar and mandrel. An adjacent table or roller on

which the sheet metal rests must be either exactly flush with, or slightly below, the top of the ground bar

and mandrel.

2) The WELD TIME knob controls the weld quality of the pinspotter. It is recommended that an initial setting

right in the middle be used and then adjust up or down accordingly in reference to the quality of welds.

TECHNICAL SPECIFICATIONS

RH Mach 70

AIR REQUIREMENTS:

Input pressure 80 PSI.

ELECTRICAL:

Input voltage: 208-240 V 60 HZ

single phase. 60 amp service

Fuse for 60 amps. using slow blow fuses

-10-