Elsema G-2000 Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Ricevitore Elsema G-2000. Elsema G-2000 13. 3g receiver with relay output for opening sliding, swing gates, doors or switching devices

Stampa la pagina
Elsema G-2000 Manuale
Setup and Programming Instructions
1. Caller ID must be enabled on all the users phone so that the G-2000 knows who's calling.
2. Open the back cover of the G-2000 and insert the SIM card.
3. Connect the power supply and switch the unit ON. The ON switch near the SIM card holder
4. Connect The G-2000 to the computer using the USB cable included.
5. On desktop, right click "My computer" >>> "Property" >>> "Hardware" >> "Device Manager".
6. Find "Ports(COM & LPT)", check the port number of "Silicon Labs CP210xUSB to UART Bridge", for
example: COM3.
7. If this driver is not visible, install the driver from the USB flash drive included.
8. Run the G-2000 configuration software, type in the COM Port number, for example:COM3 (without a
space). Click "Open", if the "COM Port" status at the bottom turns "Green", connection is successful.
9. Enter the password and Click "Log in", default password is 1234. Enter the new password if you had
previously changed it.
10. Click "Read Settings". Configure the parameters as per your application.
11. Click "Save Settings"
12. After finishing the configurations, disconnect the USB cable, restart the G-2000 to enter the working
status.
www.elsema.com
Page 3
ELSEMA
3G Receiver with relay output, G-2000