Elsner KNX L Specifiche tecniche e istruzioni per l'installazione - Pagina 3
Sfoglia online o scarica il pdf Specifiche tecniche e istruzioni per l'installazione per Accessories Elsner KNX L. Elsner KNX L 8. Brightness sensor
Resolution (brightness)
Accuracy (brightness)
The following standards have been considered for the evaluation of the product in
terms of electro magnetic compatibility:
Transient emissions:
•
EN 60730-1:2000 Section EMV (23, 26, H23, H26) (threshold category: B)
•
EN 50090-2-2:1996-11 + A1:2002-01 (threshold category: B)
•
EN 61000-6-3:2001 (threshold category: B)
Interference resistance:
•
EN 60730-1:2000 Section EMV (23, 26, H23, H26)
•
EN 50090-2-2:1996-11 + A1:2002-01
•
EN 61000-6-1:2004
The product has been tested for the above mentioned standards by an accredited EMV
laboratory.
2. Installation and commissioning
2.1. Notes on installation
Installation, inspection, commissioning and troubleshooting of
the device must only be carried out by a competent electrician.
Disconnect all lines to be assembled, and take safety precautions against accidental
switch-on.
The device is exclusively intended for appropriate use. With each inappropriate change
or non-observance of the instructions for use, any warranty or guarantee claim will be
void.
After unpacking the device, check immediately for any mechanical damages. In case of
transport damage, this must immediately notified to the supplier.
If damaged, the device must not be put into operation.
If an operation without risk may supposedly not be guaranteed, the device must be put
out of operation and be secured against accidental operation.
The device must only be operated as stationary system, i.e. only in a fitted state and
after completion of all installation and start-up works, and only in the environment in-
tended for this purpose.
KNX L brightness sensor • Date of issue: 05.11.2010 • Technical changes reserved. Errors reserved.
3
1 lux
at 0...120 lux
2 lux
at 121...1.046 lux
63 lux at 1.047...52.363 lux
423 lux at 52.364...150.000 lux
±35%
Installation and commissioning