Elsner IMSG 230 Manuale di istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Unità di controllo Elsner IMSG 230. Elsner IMSG 230 7. Motor control unit

Stampa la pagina

•

Move the drive to the starting/zero position, i.e. close the window, retract the

awning or raise the shutter.

•

Press the up and down buttons simultaneously for 3 seconds.

•

As feedback the drive briefly moves up and down. You are in now

programming mode.

•

Move to the desired position.

•

Store the position by pressing the up and down buttons for 1 second

simultaneously.

•

As feedback the drive briefly moves up and down.

•

With blind slats, now open the slats to the desired angle. For windows and

awnings, you can skip this point.

•

Store the position by pressing the up and down buttons again for 1 second

simultaneously.

•

As feedback the drive briefly moves up and down. The storage is complete and

the IMSG 230 is in normal mode again.

Note: As soon as a central command arrives (e.g. because of a wind or rain alarm), the

programming mode is interrupted! In this case, please carry out the position storage

again when the central command is no longer present.

3.1. Technical specification

Assembly

Protection category

Dimensions

Weight

Ambient temperature

Ambient humidity

Operating voltage

Inputs

Output

The following norms were consulted in evaluating this product with respect to electro-

magnetic compatibility:

EN 60730-1:2000-11 + A11:2002

The product was tested by an accredited EMC laboratory in compliance with the above-

named norms.

The product is compliant with the provisions of EU guidelines.

Motor control unit IMSG230 • Version: 05.02.2016 • Technical Changes and Errors excepted.

Installation

IP 20

approx. 38 x 47 x 30 (W x H x D, mm)

approx. 45 g

Operation -20...+70 °C, storage -55...+90°C.

max. 95% RH, avoid condensation

230 V AC, 50 Hz

• Operating voltage (Mains L1/N/PE)

• Central commands (central up/down)

• On-site button (button L1 out/up/down)

1 x Drive 230 V (PE/N/down/up), each fused at 4 A T

Storing a movement position