Dust Free 04966MV Manuale di installazione e funzionamento - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Pulitore d'aria Dust Free 04966MV. Dust Free 04966MV 8. Ultraviolet light systems

Stampa la pagina

BIO-FIGHTER

NOMAD, NOMAD 2 INSTALLATION & OPERATION MANUAL

INSTALLING THE VIEWPORT

The Nomad/Nomad 2 comes with a UV-C safe

viewport(s) that must be installed separately.

To install the viewport, select a location near

the Nomad/Nomad 2 installation and drill a

1/2" hole in the duct. Then press the viewport

into the hole. For a Nomad 2 installation, make

sure each viewport is positioned near each

lamp location.

CONNECTING TO POWER

With the Nomad/Nomad 2 installed, connect

power cord to proper power. If installing model

with whip-type power cord see Fig. 6 below for

power connection. Use the viewport to verify

lamp operation. A blue light should be seen.

Whip-type

power cord

Connect black

and white wires

to proper power.

Fig. 6 Power connection for models with whip-type power cord.

WARNING

Burn Hazard.

During replacement, allow lamps to cool 10 minutes

before removing them. Personal injury may result.

WARNING

Mercury Hazard. Do Not Break.

Each UV-C lamp contains a small amount of Mercury.

May cause redness or irritation. Use proper disposal

techniques in case of breakage.

OPERATION

The Nomad/Nomad 2 should be operated

continuously to extend the life of the lamp(s),

and to increase the effectiveness in disinfect-

ing the location selected.

INSTALL REMOTE DOOR INTERLOCK SWITCH

(Optional accessory #06150.)

Mount the remote door interlock switch so that

power to the device is automatically discon-

nected anytime the air handler access panel is

opened.

1. Remove the black remote interlock hole cap

2. Insert remote door interlock switch wire through

3. Mount remote door interlock switch and actua-

Connect green wire

to ground.

4. Check operation. Device should turn off when

Note: Remote door interlock switch includes 5 ft(1.5m)

120V power cord with custom connectors. If device is

installed more than 5 ft(1.5m) away from remote door

interlock switch, field wiring will be required in accor-

dance with national and local codes.

from the side of the Nomad/Nomad 2.

hole. Secure with strain relief. Install male and

female connector to remote door interlock switch

wires and connect to UV-C light.

tor to access panel opening.

access panel is opened.

WARNING

UV-C Light Hazard.

UV-C light can cause temporary or permanent loss of

vision, and sunburn. Take precautions to protect eyes

and skin from direct exposure.

CAUTION

Clean lamp(s) prior to installation.

Failure to remove dirt and fingerprints from the

lamp(s) could shorten their lifespan.