Dustbane Gladiator 712 + Rider Manuale operativo - Pagina 11

Sfoglia online o scarica il pdf Manuale operativo per Soffiante Dustbane Gladiator 712 + Rider. Dustbane Gladiator 712 + Rider 19. Gladiator series

6.4. Preparing the machine for work

Before starting work, wear overalls, ear protectors, non-slip shoes, mask to protect the

respiratory tract, gloves and all other personal protection devices necessitated by the work

environment.

Check that all switches on the control panel are in the "0" (off) position. Make sure you

connect the terminals marked with a "+" to the positive poles of the battery. Do not check

Important

the battery charge by sparking. Meticulously follow the instructions given below as short

circuiting the batteries could cause them to explode.

1. Rotate the top cowling through 90° towards the back of the machine

2. Place the battery/ies into the compartment.

3. Connect the battery/ies.

Mount the batteries on the machine using means suitable for their weight.

The positive and negative poles have different diameters.

Important

If you are using the machine for the first time, we recommend trying it on a large

obstacle-free surface first to acquire the necessary familiarity.

Information

Starting up/use 712 Rider:

The seat has a safety sensor which allows the machine to move only when the operator

is seated.

Information

Prepare the machine as described in the above paragraph.

1. Lift the side brush using the lifting lever.

2. Turn the key switch to the "1" position.

3. Check the LEDs to make sure the battery/ies is sufficiently charged. If not, charge the batteries.

4. Press the brush button when the brushes are active, the LED on the

5. button comes on. Pressing it again stops the brushes, the suction motor comes on automatically.

6. Use the accelerator knob to activate the drive.

7. Adjust pressure of the centre brush on the floor using the knob according to the type of floor and dirt

to be picked up. Turn it clockwise to increase pressure and anticlockwise to reduce pressure on the

work surface.

8. Lower the side brush using the lever.

9. Start cleaning, maneuvering the handgrip with the hands and acting on the drive control.

Starting up/use 712

1. Prepare the machine as described in the above paragraph.

2. Lift the side brush using the lifting lever.

3. Turn the key switch to the "1" position.

4. Check the LEDs to make sure the battery/ies is fully charged. If not, charge the batteries.