4iQ JUPITER Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Riscaldatore 4iQ JUPITER. 4iQ JUPITER 11. Panel heater 230v 2600w

Stampa la pagina

ASSEMBLY INSTRUCTIONS

INSTALLATION ACCESSORIES:

1. sliding block

2. bracket (L shape)

3. the handle screw (M6)

4. screw (M6 x 12mm)

5. washer (Ø 6mm)

6. nut (M6)

7. screw (M6 x 60mm)

INSTALLATION

This heater should be installed by a competent person, i.e. a qualified electrician.

The ideal mounting position for the panel heater is on the ceiling, directly above the area to be heated. If this is not possible, panel heater can be mounted

on a wall and angled downwards. In this situation, ensure the mounting height is in the range of 2.1-2.7m and the table is within 2.5m of the wall.

Wall/ceiling mount swivel brackets are provide with the heater which has been specifically designed to allow this product to be fitted to a wall or ceiling,

before drilling the holders for the wall/ceiling make sure it is solid and that there are no hidden water pipes or electric wires.

For mounting heights more than 2.7m, we recommend the use of the optional accessories to reduce the height of the heater to 2.3m-2.5m. This will

increase the effectiveness of your panel heater. Refer to the mounting accessory section for more information.

Electrical connections/GPO's should not be located at the back of the heater. They should be located outside the physical contour of the unit to minimize

heat build-up behind the units.

If the heater is to be mounted on an incline (eg. Vaulted ceiling), ensure the electrical connection is located at the lowest point of the heater.

STANDARD MOUNTING BRACKETS

The panel heater comes with a pair of standard mounting brackets. These adjustable brackets allow direct ceiling or wall mount, and come with preset angle options.

Step 1: Assembly the adjusting bracket to sliding bracket

Step 3: Fix adjusting bracket

into the wall or ceiling

by expansion screws.

2 szt.

4 szt.

2 szt.

8 szt.

4 szt.

Step 2: Installation of sliding bracket & heater as arrow pointed.

Step 4: Installation of two

adjusting bracket, make sure

lock brackets tight by screws